Answer Solutions Specification Guide - OEC Business Interiors

Universal Systems WorksurfacesExtended Corner, Straight-Front and Curved-FrontWorksurfacesProduct DetailsLaminate WorksurfacesFront (user’s) edgeprofile is available in twoshapes.3 mm P-edgeedge profile edge profileBoth edge profiles arevinyl (plastic), and are specifiedseparately from laminatecolor. Back and sideedges are flat.P-edge profile risesslightly above the laminatesurface and curves into a3⁄8" radius which optimizesergonomic benefit for theuser.Wood VeneerWorksurfacesFront (user’s) edge profileis wood veneer with asquare (3 mm) radius. Backedge and edge that joinsto adjacent worksurfacesare flat. Wood edge colormatches finish specified forworksurface.Edge profile is applied tofront (user’s) edge only...3 /8"P-edge profile worksurfacedepths are 3 ⁄8"deeper than 3 mm edge profileworksurfaces in order toprovide a flush interface withUniversal Pedestals.1 1 /2"1"Extended corner,straight-front worksurfacesare available with anadjustable keyboard shelf.Release lever activatescontinuous adjustment ofkeyboard surface.KeyboardMonitor6 1 /2"Left-hand Unit4 1 /2"FloorRight-hand UnitKeyboard shelf is supportedby a single arm springmechanism that allows it toadjust to positions up to 6 1 ⁄2"higher or 4 1 ⁄2" lower than themonitor worksurface..Keyboard surface tiltswith a range of 25°. Negativetilt is reduced at lower keyboardshelf heights.One-inch space separatessides of the keyboardand monitor surfaces to preventpinching. One and onehalfinch separates the back.Extended corner,straight-front andcurved-front worksurfacesare available in leftandright-hand versions..ConnectionsWorksurfaces can beused freestanding or in panelsupportedinstallations.Supports are orderedseparately and installed inthe field.For panel-supportedinstallations you can use:• Side support brackets• Cantilever with tie plate• End panel• Standing-height end panel• Support plate• Center support panel withtie plate• Standing-height centersupport panel with tie platecSee page 136 forWorksurface Supports.• Universal pedestal withfillercPage 229For freestanding installationsyou can use:• Single post leg• Single post leg with caster• Nesting post leg• Nesting post leg withcaster• Double post leg• Double post C-leg• Support platecSee page 138 for Legsand Supports for SystemsWorksurfaces.Tip: Pedestal can alsobe used in freestandinginstallations..Reinforcing channel(TS7WKSPT) is used toreinforce all worksurfaceswith 60" or more of unsupportedkneespace.cPage 137Wiring & Cabling1 /2"Worksurface depth is1⁄2" less than nominal andallows cords and cables topass over at any point. Cablescallops provide space forplugs to pass over the backedge of the worksurface.1"5"Cable scallop includes aplastic insert. On laminateworksurfaces, plastic color isdetermined by the color youspecify for the edges. Onwood veneer worksurfaces,cable scallop is available inblack plastic only.cSee page 606 for scallopcolor defaults..WorksurfacesAnswer Solutions Specification Guide cExtended Corner, Straight-Front and Curved-Front Worksurfaces, continued 113