Installation and Setup Guide - Lathem Time Corporation

PayClock Pro Installation and Setup Guidebar at the Timecard is shaded blueWhen PayClock auto deducts a break, a portion of the timeBeginning of Day - Enter when the day starts. Normally, you should leave this setting a the default of 12:00am. You can not change this setting if you have turned on the Open Schedule Override.Maximum Work Day Length - Enter how long an employee can work in one day. Normally, you shouldleave this setting at the default of 14:00 hoursCalculate Weekly OT by Total Hours - Check this box if you want PayClock to calculate overtime basedon all hours rather than regular hours. Unless your company has special rules regarding overtime, youprobably do not want to check this box5.3.1 Setup Advanced Pay Class FeaturesAt the Pay Class Advanced tab, you can set breaks, overtime calculations and workday settings• Check the Punched Break box if you want employees to punch in and out for their breaks. ThePunched Break settings apply for all employees. If you want to change a setting for oneemployee, do this under the Schedules tab at the Employees iconAt Minimum Hours from Start, enter how many hours each person must work before punching outfor a breakAt Maximum Hours from Start, enter the longest amount of time each person can work beforepunching for a breakAt Length, enter the break lengthThe green line in the schedule bar at the Timecard icon shows when aperson can clock out for breakAt Extended Break Amount, enter the max extra amount of time a person can take and the punchstill count as a break rather than an in/out punch.Note: The Extended Break A mount setting will be dimmed if the ‘Round UnscheduledRegistrations By’ on the General tab of the Pay Class icon is set to ‘Not Selected’44