Installation and Setup Guide - Lathem Time Corporation

PayClock Pro Installation and Setup GuideSection 18.1 Setup License ManagerIMPORTANT NOTEIt is very important that you only run License Manager from one computer and that you always run it fromthe same computer. Otherwise your license files will get corrupted. If this happens contact you dealer.License Manager needs to update the license files at least every 30 days. The program can do this in fourways:1. In a multi-user environment if you run License Manager from the computer that has the Basemodule installed you can add the /updatelicense switch to the PayClock Pro shortcut on thatcomputer. When you open PayClock Pro, the Base module, License Manager runs just longenough to update the license files and then shuts itself down. When using this switch, you do notsee License Manager - it works "behind the scenes". As long as you open PayClock Pro from thiscomputer at least every 30 days you will not have to run License Manager.To set PayClock Pro to open with a switch:Right click on the PayClock Pro shortcut to bring up a pop-up menu, select Properties from themenu. You will see the Properties window open, at Target type a space at the end of the line, thentype the /updatelicense switch, as shown below:Click OK, now the next time you open PayClock Pro, it will run License Manager and update yourlicense files.2. You can set the /update switch so License Manager runs just long enough to update the licensefiles once and then shuts itself down. When you open License Manager using this switch, you donot see the program - it works “behind the scenes”3. You can set the /minimized switch so License Manager stays open and will update the licensefiles once an hour. License Manager opens in minimized mode4. If you do not use a switch, License Manager stays open and will update the license files once anhour. License Manager opens in maximized mode233