Installation and Setup Guide - Lathem Time Corporation

PayClock Pro Installation and Setup Guide• Start Time / End Time - Enter the window of time the close process can begin and press enter. Awindow of time is defined just in case the computers processor is busy at the start time.Example: You can set the pay period close to start between 2:00am and 3:00am.• Note: If the Auto Close Scheduler is not able to run on the date setup it will run on the next dayduring the Start Time / End Time setting• Last Close - Displays the date of the last pay period close.• Next Close - Displays the date of the next pay period close.• Enabled Auto Close Pay Periods - Select this box to activate the automatic close for the selectedpay classesTo setup the Auto Close Scheduler follow the steps below:1. Add a setting to the RENY.INI file• RENY.INI Configuration Setting• Open Windows Explorer or File Manager• Find the PayClock application folder and locate \Database\RENY.INI.• Double click on the RENY.INI file to open it• Add this line to the [GENERAL] section• AllowAutoClose=1• From the menu select File | Save and then File | Exit2. Setup PayClock Pro to allow for the Auto Close Scheduler• Start the PayClock Pro Base Module• Select the System icon from the Setup list bar• On the General tab choose the “Close Pay Periods from Terminal Manager Only” box• Click Save to keep the changes• Exit out of the PayClock program• The Close icon will be removed from the Data list bar3. Start the Terminal Manager Module Skip this step if TCP/IP is already enabled181