Veritas Storage Foundation™ and High Availability Solutions ...

28Storage Foundation and High Availability Solutions support for Solaris ZonesConfiguring VCS in zones7 Set permissions for the zone root directory.chmod 700 zonepath8 Repeat step 2 to step 7 on each system in the service group’s SystemList.9 Mount the file system that contains the shared storage on one of the systemsthat share the storage to the directory specified in zonepath.10 Run the following command to install the zone on the system where the zonepath is mounted.zoneadm -z zonename install11 If the application data is on a loopback file system, mount the file systemcontaining the application’s data on shared storage.12 Boot the zone.zoneadm -z zonename boot13 If the application data is on a direct mount file system, mount the file systemfrom the global zone with the complete path that starts with the zone root.Performing the initial internal zone configurationWhen a zone is booted for the first time after installation, the zone is in anunconfigured state. The zone does not have an internal configuration for namingservices. Its locale and time zone have not been set, and various other configurationtasks have not been performed. You need to perform the initial internal zoneconfiguration after zone installation.You can perform the internal zone configuration in the following ways:■■sysidcfg toolZone console loginFor more details refer to Oracle documentation about "Performing the InitialInternal Zone Configuration" section in the System Administration Guide: OracleSolaris Containers-Resource Management and Oracle Solaris Zones guide.About installing applications in a zonePerform the following tasks to install the application in a zone:■If you have created zones locally on each node in the cluster, install theapplication identically in all zones on all nodes. If you are installing an