Operation Manual - ASSMANN IT-Solutions AG

CALIBRATE BATPRESS DOWN+ENTERStart of the manual Deep Battery Calibration Test.See for more information section 5.4.3 'Deep battery calibration test'PF1 THYRISTOR 1BATT.THYRISTOR 0Service information on internal UPS componentsVSS THYRISTOR 0PF1. CONVERTER 1Service information on internal UPS componentsBAT CHARGER 2INVERTER 1Service information on internal UPS componentsBatt.Charger: 0 = off, 1 = float charging; 2 = boost chargingLAST TEST TIME0:00:00Duration of latest test performed, hh/mm/ssFORCE BYPASSpress DOWN+ENTERAUTOMATIC BYPASSENABLEDBATTERY 7AhBAT. CHARGE 86%PLL LOCK SPEEDNORMALIEMMODE DISABLEDENTER/RESET CHNGAUTO RESTART ONENTER/RESET CHNGThe UPS transfers the load to bypass when the keys ‘Down’ (2) and'Enter/Reset' (3) on the front panel are pressed simultaneously for approx. 2seconds. If the bypass supply is not within limits, the lower line will show thetext 'UNAVAILABLE'.Service set-up information whether the bypass is enabled (default) or disabled.If disabled: UPS will NOT go to bypass. For disabling the bypass refer to theset-up menu (5.3.4).Service set-up information about the total battery capacity and the actualbattery charge condition. For changing the programmed battery capacity referto the set-up menu (5.3.4).Service set-up information about frequency tracking speed for the inverter tofollow the bypass frequency, LOW (1Hz/sec.) is the normal value and default.HIGH (5Hz/sec.) may be suitable if the UPS is connected to a generator withfast frequency changes and the UPS must be synchronized to prevent alarms.For changing the lock speed refer to the set-up menu (5.3.4).Service set-up information about the ECO-mode. By pressing ‘Enter/Reset’the ECO-mode can be enabled or disabled, depending on the actual status.In this way the load will be supplied by way of the electronic bypass. If theECO-mode is disabled the load will be supplied by the inverter. See also5.5.5.Service set-up information about the auto-restart function. This function canbe switched on or off by pressing ‘Enter/Reset’, depending on the actualstatus. See also 4.5.5.1 step 6.OPM_LPE_11X_3K0_10K_1GB_V041 23 GE DE LP 11 UPS: User manual 4.1 (GB)