Disperse-Ayd 6 Dispersing Agent

MATERIAL SAFETY AND PRODUCT DATA SHEETMANUFACTURER’S NAME:ELEMENTIS SPECIALTIESSTREET ADDRESS:400 CLAREMONT AVENUECITY, STATE & ZIP CODE: JERSEY CITY, NJ 07304INFORMATION TELEPHONE NO: (201) 432-0800EMERGENCY 24-hr TELEPHONE NO: (800) 424-9300 (CHEMTREC)HEALTH__2__FLAMMABILITY__3__REACTIVITY__1__PERS. PROTEC. EQUIP__H__SECTION I - IDENTITYCommon NameUsed on Label: DISPERSE-AYD 6 Chemical Name: N/A: MixtureTrade Names andSynonyms: Dispersing Agent Formula: N/A: MixtureCAS Number:Chemical Family:COMPOSITIONNot Required (Mixture).Anionic Surfactants/Fatty EstersComponents not specifically identified by CAS Number and/or Chemical Name are protected under“trade secret” or “proprietary information” provisions of PA Ch. 317.2 (1987).CHEMICAL NAME CAS Number % by Weight % by VolumeActive Solids Proprietary 82.0 80.1Xylene 1330-20-7 11.4 13.3Denatured Ethanol 64-17-5 1.0 1.0Water 7732-18-5 5.6 5.6SECTION II - HAZARDOUS INGREDIENTSHAZARDOUS COMPONENT CAS Number ACGIH TLV/ppm OSHA PEL/ppm % by VolumeNone known unless listed below.Xylene* 1330-20-7 100 100 10.6Ethyl Benzene (in Xylene)* 100-41-4 100 100 2.7Ethanol 64-17-5 1000 1000 1.0Polydimethylsiloxane 70131-67-8 Not Established Not Established 2.0Page 1

Product Disperse-Ayd 6 Dispersing AgentSECTION III - PHYSICAL & CHEMICAL CHARACTERISTICS (Fire & Explosion Data)BoilingPoint/Range: 280-288 F Vapor Pressure (mm Hg 25?C): 6.0Volatile OrganicContent (VOC): 1.16 lbs/gal; 139 gr/L Vapor Density ( Air = 1): 3.7Solubilityin Water: Insoluble Reactivity in Water: NoneAppearance & Odor:Amber liquid/paste; aromatic odor.Wt/Gal:Lbs (Sp Gr): 8.4 lbs/gal (1.01) Evaporation Rate (BuAct=1): < 1.0Flammable Limits in AirFlash Point: 80 F (26.7 C) % by Volume (Lower/Upper): 1.0/7.0Threshold LimitOSHA Permissible ExposureValue (TLV) in PPM: 100 Level (PEL) in PPM: 100Extinguisher Media:Fire FightingProcedures:Unusual Fire andExplosion Hazards:Water fog; foam; carbon dioxide; dry chemical.DO NOT use water, except as FOAM.Keep away from excessive heat or open flame.SECTION IV - PHYSICAL HAZARDSStability: (X) Stable ( ) UnstableConditions to Avoid: Keep away from excessive heat or open flame.HazardousDecomposition Products: Combustion will produce carbon dioxide and possibly carbon monoxide.HazardousPolymerization: ( ) May occur (X) Will not occur.Conditions to Avoid: Keep away from excessive heat or open flame.SECTION V - Health HazardsSigns & Symptoms of Exposure and Routes of EntryInhalation:Skin:Ingestion:Eyes:Irritant to respiratory tract. Prolonged breathing of vapors can cause dizziness, headache, nausea.Irritant. Prolonged or repeated contact can cause defatting and/or dermatitis.May cause irritation of digestive tract; drowsiness, dizziness; loss of coordination; fatigue.Direct contact may cause burning, tearing, redness, swelling.Page 2

Product: Disperse-Ayd 6 Dispersing AgentSECTION VI - SPECIAL PROTECTION INFORMATIONEmergency and First Aid ProceduresInhalation:Skin:Ingestion:Eyes:Remove victim to fresh air. Get medical attention.Wash well with soap and water; remove contaminated clohing and wash before reuse.DO NOT induce vomiting. Get immediate medical attention.Flush eyes with clean water for 15 minutes; get immediate medical attention.Chemical Listed as Carcinogenor as Potential Carcinogen in (a) OSHA: No (b) IARC: No (c) National Toxicology Program: NoIf “Yes”, explain:RespiratoryProtection (Type):Ventilation:ProtectiveGloves:Eye Protection:Other ProtectiveClothing/Equipment:NIOSH-approved respirator as required for organic solvents.Area should be well ventilated and equipped with adequate exhaust system.Impervious gloves.Safety goggles or glasses.Rubber apron; eye bath; safety shower.SECTION VII - SPILL AND LEAK PROCEDURESStoring/Handling:Release or Spill:Waste Disposal:Store away from excessive heat or open flame. Use spark-proof tools.Eliminate all ignition sources. Use spark-proof tools. Add absorbent; transfer toappropriate container.Dispose of according to local, state and Federal regulations.SECTION VIII - REGULATORY DATAHeavy Metal Content (in PPM unless otherwise noted)ANTIMONY:

Product: Disperse-Ayd 6 Dispersing AgentSection VIII - Regulatory Data Continued…CHEMICAL INVENTORIES:EPA SARA TITLE III:FDA STATUS:Components are listed on US TSCA, Canadian DSL, European EINECS.Any component subject to Section 313 is asterisked in Section II.The non-volatile portion of this product is cleared under the following Title 21 CFRParagraphs: 175.300; 176.170.EXPLANATION OFABBREVIATIONS: N/A: Not Available/Not Applicable. N/D: Not Determined PPM: Parts Per MillionWARNING:This product contains chemicals known to the State of California to cause cancer.This product contains chemicals known to the State of California to cause birth defects or otherreproductive harm.This product is not subject to reporting under California Proposition 65.California Proposition 65 reporting requirement not determined.Issue Date: 20 May 1992 Approved By: PRODUCT SAFETY DEPARTMENTELEMENTIS SPECIALTIESReview Date: 26 Jun 1995Review Date: 28 Mar 1998Review Date: 27 Jul 2000Review Date: 05 Feb 2001Review Date: 15 Jan 2002Revision/s: Section II Ethanol and Polymethyldisiloxane added.Revision/s: New FormatRevision/s: Sec I - Composition; Sec III - VOCRevision/s: No Change.Revision/s: No changeThe data set forth in these sheets are based on information provided by the suppliers of the raw materials and chemicalsused in the manufacture of the aforementioned product. ELEMENTIS SPECIALTIES makes no warranty with respect tothe accuracy of the information provided by their suppliers, and disclaims all liability of reliance thereon.ELEMENTIS SPECIALTIES warrants only that its products conform with their published specifications, and no otherexpress warranty is made with regard therefor. We do not guarantee favorable results, and we assume no liability inconnection with the use of the products. They are intended for use by persons having technical skill and knowledge, attheir own discretion and risk.Page 4