SAM4s ER-290 Operators Manual.pdf

Programming Department Status1. Turn the control lock to the PGM position.2. Decide if you want a negative, enforced non-add entry, or disabled department. If youdo not want any of these department options, enter 0. If you wish to select any of theseoptions, complete the table below by adding the status digits for each option. Enter theresulting digit.Department isNegativeEnforce Non-AddEntryYes = 1No = 0Yes = 2No = 0Department is Disabled Yes =4No = 0+++3. Decide if you want a preset or single item department. If you do not want any of thesedepartment options, enter 0. If you wish to select any of these options, complete thetable below by adding the status digits for each option. Enter the resulting digit.=Department is Preset Yes = 1No = 0Allow Preset Override Yes = 2No = 0Department is SingleItemYes = 4No = 0+++4. Complete the tax status table below by adding the status digits for each tax. Then enterthe resulting tax status code.=Taxable by Rate 1? Yes = 1No = 0Taxable by Rate 2? Yes = 2No = 0Taxable by Rate 3? Yes = 4No = 0Taxable by Rate 4? Yes = 8No = 0++++=5. Press the @/FOR key.6. Repeat steps 2 through 5 for each department you wish to program.7. Press the CASH/TEND key to end programming.44 • Advanced Programming Instructions ER-290 Electronic Cash Register