Aircraftspruce & Specialty Co. - NavirNet

2006_209-216.qxd 6/27/06 6:32 PM Page 212
CM
WP
ME
HA
AP
LG
EP
CS
IN
EL
AV
TO
PS
BV
BV
PA18 UPPER DOOR
Constructed using all square tubing. FAA
approved.
P/N 05-00459 ......................$287.95
PA18 LOWER DOOR
Latching mechanism greatly improved
over original. Utilizes push rods instead of
wires. Powder coated.
P/N 05-00460 ......................$460.95
PA18 STABILIZER
Bushings installed, powder coated and
ready to cover. FAA-PMA approved.
P/N 05-00461 ......................$345.95
PA18 ELEVATOR
Bushings installed, powder coated and
ready to cover. FAA-PMA approved.
P/N 05-00462 ......................$345.95
PA18 RUDDER
Bushings installed, powder coated and
ready to cover. FAA-PMA approved.
P/N 05-00463 ......................$373.95
PA18 VERTICAL FIN
Bushings installed, powder coated and
ready to cover. FAA-PMA approved.
P/N 05-00464 ......................$271.95
CUB TYPE AXLES
1-1/2 inch Axle, Cub Type, Weld On.
FAA-PMA Approved Left and Right
Axle Assemblies Sold Separately
1-1/2” (R) P/N 05-02139 ........$62.25
1-1/4” (L) P/N 05-02142 ........$62.25
PA18 TAILPOST
Bushings installed, powder coated and
ready to cover. FAA-PMA approved.
P/N 05-00465 ........................$62.25
$10 CRATE CHARGE FOR ALL ITEMS ABOVE
SUPERCUB PARTS
FLAP HINGE-OUTBOARD
For fabric wing piper models, powder coated.
FAA-PMA approved.
P/N 05-00480 ........................$58.50
212
COMPLETE SUPERCUB FUSELAGE
Replacement fuselage for the PA 18 Supercub incorporating
the latest improvements and mods. The fuselage tubes and
fittings are all 4130 steel and the standard mods are: “X” reinforcement
in the top deck, extended baggage with “dog leg”
bulkhead reversed, standard baggage area increased to 180
lbs. capacity, removable rear seat bar, reinforcement sleeves
under stabilizer attach bracket, modernized tabs and attach
brackets. Completely FAA approved under PMA and STC.
Excellent workmanship.
P/N 05-00466..........................$10,865.00
Shipped freight collect from factory in Alaska.
Add $900 crate fee.
SEALED LIFETIME STRUTS
WITH HEAVY DUTY FORKS
FAA-PMA - complies with all A.D.’s - high strength struts will not fail
under wind or snow loads.
PA 18 Front Lift Strut -..........................P/N 05-00485 ......$419.95
PA 18 High Strength Rear Lift Strut - ..P/N 05-00486 ......$471.95
PA 12-14 Front Lift Strut - ....................P/N 05-00487 ......$418.95
PA 12-14 High Strength Rear Lift Strut - P/N 05-00488....$471.95
$20 CRATE CHARGE FOR LIFT STRUTS
PA18 ARCHES FOR
FABRIC FORMERS
Complete set of 6 “turtle deck” arches precut
to correct size, weld on as is. FAA-PMA
P/N 04-00469 ..........per set $195.95
PA 18 WING FITTINGS
Weld on, FAA-PMA approved.
Front left side ..................P/N 05-00470 ........$59.95
Front right side ................P/N 05-00471 ........$59.95
Rear left side ..................P/N 05-00472 ........$35.00
Rear right side ................P/N 05-00473 ........$35.00
PA 18 REAR GEAR FITTING
Weld on, FAA-PMA approved.
Left side ......................P/N 05-00474 ......$143.95
Right side ....................P/N 05-00475 ......$143.95
PA 18 FRONT GEAR FITTING
Weld on, FAA-PMA approved. Fits right or left side.
P/N 05-00476 ......$113.95
WELD-ON FLOAT FITTING
Weld-on float fitting for all models Piper
Supercub, PA18. FAA approved by STC. Weighs
less than similar fittings. $475.00 for a pair.
P/N 05-02529.........$113.95
PA 18 FUSELAGE HANDLE
Oversized lifting handle can be used with
winter gloves, 8” long with 2” clearance.
Weld on, FAA-PMA approved.
P/N 05-00477 ........$30.90
AILERON HINGE
For fabric wing piper models. Powder coated.
FAA-PMA approved. P/N 05-00478 ........$51.00
AIRCRAFT SPRUCE WEST AIRCRAFT SPRUCE EAST
CORONA, CA • (877) 4-SPRUCE Prices Subject to Change Without Notice
PEACHTREE CITY, GA • (877) 477-7823