Manual - Pine Tree Stove Shoppe

62.3 GENERAL INSTRUCTIONS! WARNINGALL WIRING SHOULD BE DONE BY A QUALIFIED ELECTRICIAN AND SHALL BE IN COMPLIANCE WITHLOCAL CODES. IN THE ABSENCE OF LOCAL CODES, USE THE CURRENT CSA22.1 CANADIANELECTRIC CODE IN CANADA OR THE CURRENT NATIONAL ELECTRIC CODE ANSI/NFPA NO. 70 INTHE UNITED STATES.THIS APPLIANCE HAS NOT BEEN TESTED WITH ANY VENTED OR UNVENTED GAS LOG SET. TOREDUCE RISK OF FIRE OR PREVENT INJURY, DO NOT INSTALL A VENTED OR UNVENTED GAS LOGSET INTO THE APPLIANCE.BURNING YOUR UNIT WITH THE ASH DUMP DOOR OPEN OR AJAR CREATES A FIRE HAZARD THATMAY RESULT IN DISCOLOURATION TO THE GOLD PLATED DOOR, INTERNAL DAMAGE TO THEAPPLIANCE OR A HOUSE CHIMNEY FIRE.DO NOT CONNECT THIS APPLIANCE TO A CHIMNEY FLUE SERVING ANOTHER APPLIANCE.THIS APPLIANCE AND IT’S COMPONENTS ARE DESIGNED TO BE INSTALLED AND OPERATED AS ASYSTEM. ANY ALTERATION TO OR SUBSTITUTION FOR ITEMS IN THIS SYSTEM, UNLESS ALLOWEDBY THESE INSTALLATION INSTRUCTIONS, WILL VOID THE LISTING AND MAY VOID THE PRODUCTWARRANTY. IT MAY ALSO CREATE A HAZARDOUS INSTALLATION. READ THROUGH THESEINSTRUCTIONS THOROUGHLY BEFORE STARTING YOUR INSTALLATION AND FOLLOW THEMCAREFULLY THROUGHOUT YOUR PROJECT.• Before beginning your installation, consult with your local building code agency or fi re offi cials andinsurance representative to ensure compliance.• Non-toxic smoke will be emitted during the paint curing process, to help dissipate the smoke open awindow near the appliance.• Remove any dust or debris off the top of the appliance before fi ring the appliance as the paint will becomesoft as the appliance heats up and will harden as the appliance cures. To cure the paint on yourappliance burn your appliance moderately hot during the fi rst few fi res.• To keep the gasket from sticking to the appliance as the paint is curing, periodically open the doorevery 5-10 minutes.• For the fi rst two weeks use generous amounts of fuel and burn the appliance with the damper wideopen for an hour as the appliance goes through a process of eliminating moisture in the steel and fi rebricks.The initial heat output will be reduced while the moisture is bring drawn from the appliance andit will be necessary to build several hot fi res to remove this moisture. DURING THIS PROCESS DONOT OVERFIRE THE APPLIANCE. REDUCE THE AMOUNT OF AIR COMING INTO THE APPLI-ANCE IF THE APPLIANCE OR CHIMNEY BECOMES RED.4.7W415-0762 / B / 11.12.10