Manual - Pine Tree Stove Shoppe

3310.0 TROUBLE SHOOTING! WARNINGTURN OFF THE ELECTRICAL POWER BEFORE SERVICING THE APPLIANCE.APPLIANCE MAY BE HOT, DO NOT SERVICE UNTIL APPLIANCE HAS COOLED.DO NOT USE ABRASIVE CLEANERS.WHEN CHECKING CONNECTIONS, INSTALLING JUMPER WIRES (FOR TEST PURPOSES ONLY) ORREPLACING COMPONENTS, UNPLUG HEATER FROM THE RECEPTACLE TO PREVENT ELECTRICALSHOCK OR DAMAGE TO THE COMPONENT.PROBLEMCan’t get the fi re started.Smokes when door isopen.Appliance emits odour.Stove doesn’t burnt hotenough.Wood burns too fast.Dirty glass.Blower does not run.SOLUTION- Not enough kindling / paper? Add more.- Not enough air? Ensure air control is fully open.- Cold air blockage? Burn a piece of paper to establish a draft.- Use dry seasoned wood.- Flue blockage? Inspect chimney.- Cold air blockage? Burn a piece of paper to establish a draft.- Insufficient draft? Add more pipe.- Let air stabilize before opening door.- Ensure baffl es are positioned correctly.- Negative pressure? Open a window near the appliance.- Paint curing. See “GENERAL INSTRUCTIONS” section.- Wood is too wet.- Insufficient draft? Add more pipe.- Not enough air? Ensure air control is fully open.- Air control may need to be adjusted down.- Check to see ash plug is properly seated (if equipped).- Check door gasket for adequate seal.- Wood may be extremely dry.- Air control may be closed too far.- Burn hotter, smaller fi res.- Use well seasoned wood.- Appliance may not be up to temperature.- Ensure blower has power.42.14AW415-0762 / B / 11.12.10