Manual - Pine Tree Stove Shoppe

8.7 CARE OF GLASSIf the glass is not kept clean permanent discolouration and / orblemishes may result. Normally a hot fire will clean the glass.The most common reasons for dirty glass include: not usingsufficient fuel to get the appliance thoroughly hot, using greenor wet wood, closing the draft so far that there is insufficient airfor complete combustion.If it is necessary to clean the glass, buff lightly with a clean drycloth and non-abrasive cleaner.! WARNINGHOT GLASS WILLCAUSE BURNS.DO NOT TOUCH GLASSUNTIL COOLED.NEVER ALLOW CHILDRENTO TOUCH GLASS.29DO NOT CLEAN GLASS WHEN HOT! Clean the glass after the fi rst 10 hours of operation with arecommended appliance glass cleaner. Thereafter clean as required.The glass is very strong but do not let burning fuel rest or fall against it and always close the door gently.NEVER FORCE IT SHUT!If the glass should ever crack or break while the fi re is burning, do not open the door until the fi re is out and donot operate the appliance again until the glass has been replaced, available from your Authorized dealer. DONOT SUBSTITUTE MATERIALS.5.38.8 CARE OF PLATED PARTSIf the appliance is equipped with plated parts, you must clean fi ngerprints or other marks from the platedsurfaces before operating the appliance for the fi rst time. Use a glass cleaner or vinegar and towel to clean.If not cleaned properly before operating for the fi rst time, the marks can cause permanent blemishes onthe plating. After the plating is cured, the fi ngerprints and oils will not affect the fi nish and little maintenanceis required, just wipe clean as needed. Prolonged high temperature burning with the door ajar may causediscolouration on plated parts.NOTE: The protective wrap on plated parts is best removed when the assembly is at roomtemperature but this can be improved if the assembly is warmed, using a hair dryer or similar heatsource.6.1W415-0762 / B / 11.12.10