Manual - Pine Tree Stove Shoppe

195.0 FINISHING5.1 LEG INSTALLATION (1100PL / 1400PL)To avoid being damaged during shipping, the appliance has been bolted to the palletand must be unbolted before the appliance can be installed.A. Remove the 4 nuts and washers fromthe underside of the pallet.B. Lift the appliance up and away fromthe pallet to clear the threaded studssticking through the pallet. Placethe appliance on its back onto aprotective surface such as a carpet orblanket to avoid scratches during leginstallation.C. Remove the four additional nuts fromeach of the four studs.D. Use four of the nuts and washers removed above to install the legs as illustrated.E. Lift the appliance up and gently set down on all four legs. Do not pivot appliance up on its legs, as thiscould result in damage to the legs.5.2 DOOR REMOVAL / INSTALLATION (1100PL / 1400PL)A. Pivot the door open and lift up to clear thebushings. Do not pivot the door any further thannecessary.B. Carefully set the door aside and pull the pins outfrom the door bushings. Repeat in reverse order toinstall the door.PINS5.3 1100C/1400C DOOR REMOVAL / INSTALLATIONA. 1400C only: Remove the cast lid.B. Remove cast top.C. Pull pin from top door hinge. It is important to hold the door whileremoving the pin. Pivot the door to clear the top door hinge. Lift the dooroff of the lower pin. Do not pivot the door any further than necessary.Repeat in reverse order to install the door.DOOR ADJUSTMENT: Loosen screws of top door bracket and slide side to sideto adjust the door hinge. Close door against paper seal to ensure proper doorseal.W415-0762 / B / 11.12.10