Manual - Pine Tree Stove Shoppe

More documents

Recommendations

Info

184.1.5 TYPICAL EXISTING MASONRYYou can also install your appliance using yourexisting masonry chimney. To do so, follow theguidelines below. You may want to use a factorybuiltthimble, or construct your own brick thimble.If you are using a masonry chimney, it isimportant that it be built in compliance withthe specifi cations of the Building Code inRAFTERyour region. It must normally be lined withfi re clay bricks, metal or clay tiles sealed CLEARANCE WITH FIRESTOPtogether with fi re cement. (Round fl ues arethe most effi cient). The maximum fl ue sizeis 8” x 8” square or 6” round.CEILING JOISTCOMBUSTIBLEWALLEAVECLEARANCECHIMNEYCONNECTORTHIMBLEFLOORPROTECTOR62.1W415-0762 / B / 11.12.10
195.0 FINISHING5.1 LEG INSTALLATION (1100PL / 1400PL)To avoid being damaged during shipping, the appliance has been bolted to the palletand must be unbolted before the appliance can be installed.A. Remove the 4 nuts and washers fromthe underside of the pallet.B. Lift the appliance up and away fromthe pallet to clear the threaded studssticking through the pallet. Placethe appliance on its back onto aprotective surface such as a carpet orblanket to avoid scratches during leginstallation.C. Remove the four additional nuts fromeach of the four studs.D. Use four of the nuts and washers removed above to install the legs as illustrated.E. Lift the appliance up and gently set down on all four legs. Do not pivot appliance up on its legs, as thiscould result in damage to the legs.5.2 DOOR REMOVAL / INSTALLATION (1100PL / 1400PL)A. Pivot the door open and lift up to clear thebushings. Do not pivot the door any further thannecessary.B. Carefully set the door aside and pull the pins outfrom the door bushings. Repeat in reverse order toinstall the door.PINS5.3 1100C/1400C DOOR REMOVAL / INSTALLATIONA. 1400C only: Remove the cast lid.B. Remove cast top.C. Pull pin from top door hinge. It is important to hold the door whileremoving the pin. Pivot the door to clear the top door hinge. Lift the dooroff of the lower pin. Do not pivot the door any further than necessary.Repeat in reverse order to install the door.DOOR ADJUSTMENT: Loosen screws of top door bracket and slide side to sideto adjust the door hinge. Close door against paper seal to ensure proper doorseal.W415-0762 / B / 11.12.10
Page 1 and 2: INSTALLER: LEAVE THIS MANUAL WITH T
Page 3 and 4: 31.0 INSTALLATION OVERVIEW1400PL IL
Page 5 and 6: 52.1 DIMENSIONSBCADE1400PL ILLUSTRA
Page 7 and 8: 2.4 GENERAL INFORMATION! WARNINGDO
Page 9 and 10: 93.0 PRE-INSTALLATION PREPARATION3.
Page 11 and 12: 113.6 MOBILE HOME! WARNINGDO NOT IN
Page 13 and 14: 4.1 CHIMNEY! WARNINGNEVER INSTALL A
Page 15 and 16: 154.1.2 ADDING SECTIONSAdd chimney
Page 17: 174.1.4 TYPICAL THROUGH THE WALLIf
Page 21 and 22: 215.6 BRICKS AND BAFFLES INSTALLATI
Page 23 and 24: 237.0 OPERATION! WARNINGALWAYS OPER
Page 25 and 26: 257.3 LIGHTING A FIRE7.3.1 FLASH FI
Page 27 and 28: 278.3 RUNAWAY OR CHIMNEY FIREA CHIM
Page 29 and 30: 8.7 CARE OF GLASSIf the glass is no
Page 31 and 32: 9.0 REPLACEMENTSContact your dealer
Page 33 and 34: 3310.0 TROUBLE SHOOTING! WARNINGTUR
Page 35 and 36: 3512.0 SERVICE HISTORY43.1W415-0762

Manual - Pine Tree Stove Shoppe

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?