equipment sourcebook - Loctite.ph

MOTIONCONTROLLOCTITE ® ADVANCING SLIDE DISPENSE STATIONItem Number: 98426The Loctite® Advancing Slide Dispense Station is used for repetitive dot dispensing or pottingoperations that require motion in the z-axis. It is a fully integrated system that will control anysyringe, cartridge or dispense valve; no separate dispense controller is required. The rugged, allmetalconstruction is designed for tough manufacturing environments.Features:• Integrated solution – plug and play• Compact size• Precision timers with accuracy to 0.1 second• Robust slide design• Stroke adjustment 0 to 2"• Adjustable height, position and angle of dispense point• Sturdy work surface with 4 mounting holes for part fixturing• Rugged, all-metal enclosure• Vacuum suck-back to eliminate drips when syringe dispensing• Auto repeat mode cycles unit continuously without foot switch• Wide variety of mounting hardware availableInstallation OverviewA mounting bracket must be purchased separately to hold thesyringe, cartridge, or valve. The mounting bracket simply slidesover the 3 3 ⁄4" mounting rail that is attached to the bottom ofthe slide and is secured using a nylon screw. Once thedispenser is attached, the pneumatic dispense controls arepressed into the clearly labeled connections. The pneumaticdispense control fittings are 1 ⁄4" female NPT fittings and themost commonly required fittings to integrate a syringe,cartridge or valve are supplied.The height, position and angle of the dispense point caneasily be adjusted using the stand clamps. The stand clamps arespecifically designed to adjust effortlessly yet consistently holdtheir position during operation.The dispensing process is controlled using five variables thatare easy to adjust, set, and monitor. All timers have adjustableranges that yield good precision over a very wide range.VARIABLEDispense pressureDelay time before dispenseDispense timeSlide down timeAuto cycle timeRequired Separate PurchasesRANGE0 to 90 psi0.1 sec to 500 hours0.1 sec to 500 hours0.1 sec to 500 hours0.1 sec to 500 hours• Dispense valve, syringe adapter, or cartridge adapter• Mounting bracket• Dispense needles• Fixture to locate part(s)• Tubing for connecting valve(s) and air inTECHNICAL SPECIFICATIONSAttributeValueDispense PatternDots or pottingNumber of Dispense Points 1Slide Stroke 0 to 2"Maximum Part Height 1* 12"Width 12"Dimensions Depth 14.75"Height 28"Weight25 lbs.Weight Capacity 2*50 lbs.Vacuum Range1 to 15 inches HgAir InputClean, dry air not to exceed 125 psig and filteredwith a maximum of 50 micronsAir Output0 to 100 psiPower Source110/220 VAC; 50/60 HzProgramming4 Adjustable Range Analog TimersParts Included(1) Advancing Slide Dispense Station(1) Fitting Kit for Dispenser Connection(1) Foot Switch (1) Power Cord (1) ManualAdditional Information For Valve Dispensing, see pages 64-74.For Syringe Dispensing, see page 83.For Mounting Hardware, see page 95.For Dispensing Tips, see pages 80-81.* For explanation of notes 1 and 2, please refer to notesbelow the chart on page 92.Dispense StationsFor additional information and the full line of equipment, visit www.equipment.loctite.com.93