Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
58 / SERVICE<br />
pict 62<br />
• both sides of the heel track (inside) over the<br />
entire length.<br />
• the bearings of the opened hand lever on both<br />
sides. (pict 63).<br />
pict 63<br />
• the guiding channel of the release setting<br />
adjustment screw.<br />
After finishing the heel lubrication slide on the<br />
heel and lock it in its original position.<br />
SL 45 and SR 45<br />
Lubricate<br />
• both sides of the heel track (inside) over the<br />
entire length.<br />
• the contact areas between housing and the<br />
release cam on the frontside an the backside<br />
as shown in pict 64 and 65.<br />
pict 64<br />
• the guiding channel of the release setting<br />
adjustment screw (pict 65).<br />
pict 65<br />
After finishing the heel lubrication slide on the<br />
heel and lock it in its original position.<br />
Not to be Lubricated<br />
The locking element and the corresponding holes<br />
in the heel track should be cleaned but not lubricated.<br />
This could prevent dirt accumulation in this area,<br />
which could interfere with the ease of handling.<br />
Test your Drill Template<br />
A worn or damaged drill template could create a<br />
lot of trouble. Please check your templates periodically:<br />
1. Position the fully extended drill template on a<br />
discarded ski.<br />
2. Turn the clamping lever to open the clamping<br />
jaws of the mounting template.<br />
3. Position the template properly on the ski so<br />
that the boot center marking is aligned with<br />
the mounting point described on the ski.<br />
4. Let go of the clamping lever. The template<br />
clamps automatically.<br />
5. Drill all the holes.<br />
6. Remove the mounting template and clean the<br />
ski.<br />
7. Measure the holes with a slide gauge.<br />
8. The distance of the screw holes to the edge of<br />
the ski must be equal for each pair of related<br />
holes. The deviation must not be more than<br />
1 mm.<br />
9. The mounting template must be discarded if<br />
greater deviations occur!<br />
Repair of damaged Mounting<br />
Holes or broken Screws<br />
For repairing damaged holes, we suggest our<br />
special “Repair Set” – art. nr. 162 127.<br />
It consists of a hollow drill bit and plastic inserts<br />
(pict 66).
Change language