Technical Manual 2005/06 - Tyrolia

56 / SERVICE
locking lever and pull off the heel backwards.
Remove the inserts and mount the new ones
(pict 57).
pict 57
Colors of the heel glide inserts:
black/white: art. nr. 162 357
red/yellow: art. nr. 162 510
Lubricate the new inserts with TYROLIA grease,
clean the heel track, and slide the heel back into
the track. Lock the locking lever into the same
position it was before, remount the brake and
tighten the screws.
For remounting the brake it is necessary that the
cross-bolt of the brake is located under the hooks
of the heel track. The brake has to be in the upright-braking
position (pict 58).
pict 58
Replacing the heel glide inserts
for Railflex Lite heel
Remove the center screw and slide the binding off.
Separate the heel from the Railflex band and turn
the heel around. Remove the inserts and replace
them with new ones (pict 59).
pict 59
Spare part-Indentification
Most of the replaceable parts have an article
number (000 000) imprinted on the bottom.
Reference this number when you order spare
parts to prevent confusion.
Long & short screws
SL 70 ABS, SL 70, SP 70 and SR 70 are delivered
with screws for ski lengths under 140 cm (penetration
depth 6mm). If they are mounted on
longer skis, the screws have to be replaced with
longer screws. (penetration depth 8 mm – see
screw chart on page 39).
Tapping
TYROLIA recommends tapping the drilled binding
holes of any ski before mounting. Of course, there
is a never-ending discussion among the mechanics
if this is really necessary.
But the pros are convincing:
• smooth and easy mounting
• reduced risk of stripping a screw
• same momentum adjustment of the screwdriver
regardless of the ski material
• increased mounting quality/precision
• fewer pull outs.
Template “Adapter”-Set
(art. nr. 162 569)
Compatible to all TYROLIA-Template.
Warning: Avoid dropping of the template.
The clamping jaws could be damaged.
59-108 mm
SKI
1
50-99 mm
SKI
For skis with integrated our mounted plates.
1