Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Railflex Lite Base only<br />
15mm<br />
Boot Center Adjustment:<br />
Depending on the position selected the skiing<br />
behavior of the system is different (see below).<br />
+ 15<br />
0<br />
- 15<br />
15mm<br />
1. Moderate Speed<br />
The center of the body<br />
is shifted to the front.<br />
The ski reacts earlier<br />
and can be controlled<br />
easily. Good for skiers<br />
preferring moderate<br />
speeds.<br />
2. All-around<br />
3. Experts<br />
pict 42<br />
Neutral adjustment<br />
for optimal all aroundperformance.<br />
For every skier!<br />
By shifting the center<br />
of the body backwards,<br />
the ski is more stable.<br />
Better speed at the end<br />
of the run. For experts<br />
and terrain skiers.<br />
5. Forward pressure control<br />
Railflex SystemII<br />
MOUNTING/ 35<br />
Place the boot in the binding and close it. The indicating<br />
pointer should rest within the scribed area<br />
(8). If not lift the tooth lock with a screwdriver, adjust<br />
the forward pressure and lock the tooth lock<br />
again. The adjustment range is +- 4 mm, the last<br />
position to the front and the rear is reached if the<br />
indicating pointer (1) or (2) is aligned with the rear<br />
end of the steel base plate (3) (see pict 43).<br />
●➊<br />
➌● ●➋<br />
pict 43<br />
Note: Always remove the boot before opening<br />
the toothed lock.<br />
Check the forward pressure again.<br />
Railflex Lite System<br />
Place the boot in the binding and close it. The indicating<br />
pointer should rest within the scribed area<br />
(Nr. 1). If not, lift the tooth lock with a screwdriver,<br />
adjust the forward pressure and lock the tooth<br />
lock again. The adjustment range is ± 4mm (see<br />
pict 44).<br />
Note: Always remove the boot before opening<br />
the toothed lock.<br />
Check the forward pressure again and if<br />
necessary repeat this procedure.<br />
6. Adjustment of the release values<br />
The release values at toe and heel should be<br />
determined by height and body weight<br />
(ISO/ASTM) method. Set the binding accordingly<br />
with the adjustment screws. We recommend the<br />
use of a calibrated testing device and that you<br />
keep a written record of whether the system<br />
passes or fails (requirement in the US).<br />
➑<br />
❶<br />
pict 44