Technical Manual 2005/06 - Tyrolia

32 / MOUNTING
Note: Keep in mind that some ski manufacturers
do not use the center of boot sole location
method. Always follow the ski manufacturer’s
instructions.
3. Drilling the holes
If not otherwise specified by the ski manufacturer
use for all bases a 4.1 Ø x 9.0 mm drill bit for skis
140 cm and longer. For skis shorter than 140 cm
use a 4.1 Ø x 7.0 mm drill bit.
Drill through the appropriate bushings:
If required Model by the ski manufacturer, Color of tap indicator the hole.
Super Railflex BaseII
Railflex BaseII
Railflex Lite Base black
After drilling place a drop of TYROLIA glue into
the holes. It lubricates the screws and seals the
holes (pict 28).
pict 28
4. Mounting
(SUPER) RAILFLEX BASEII
Place the front section of the (SUPER) RAILFLEX
BASEII over the holes and tighten the screws.
Place the rear section over the holes and tighten
the screws (pict 29).
pict 29
Cover the (SUPER) RAILFLEX BASEII with the
appropriate Covers (pict 30).
pict 30
silver
RAILFLEX SystemII
Mounting of the Railflex SystemII
Make sure that the boot is satisfying the international
standards and has no functional damage.
Determine the boot sole length with the TYROLIA
Rental boot caliper art. nr. 162 617 (pict 31).
Connect the toe and heel with the Railflexband at
the closest sole length mark corresponding to the
measured boot sole length (pict 32).
pict 32
pict 31
Slide the binding on the Railflexbase from the rear
until the mark on the band cover is aligned with the
selected mark on the center piece (+15/0/-15).
Make sure that all components of the binding are
engaged with the base.
Then fix the binding position by tightening the
screw in the center piece (pict 33).