Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
The arrow (2) on the CYBER bridge should point<br />
to the selected centimeter mark (pict 7).<br />
pict 7<br />
Carefully place the toe with the attached CYBER<br />
bridge over the prepared holes and fasten the<br />
screws. Attach the heel to the CYBER bridge by<br />
placing the steel hook located below the ski brake<br />
into the rear slot of the bridge. It is important that<br />
you just insert the rear heel screws and then the<br />
front.<br />
For SL 110 CARVE ABS:<br />
Connect the Carve-Flex-Mid-plate with tab<br />
located under the heel base plate (pict 8).<br />
pict 8<br />
Place the assembly over the prepared holes and<br />
fasten the screws. Place the toe over the Carve-<br />
Flex-Mid-Plate and the drilled holes and fasten<br />
the screws. Drive the rear screws first, then the<br />
front screws.<br />
For other bindings:<br />
Place the binding over the predrilled holes and<br />
drive the screws.<br />
6. Forward pressure control<br />
❷2<br />
Place the boot in the binding.<br />
The indicator (location depends on the heel type)<br />
must be within the scribed area. Readjust boot<br />
sole length if necessary (pict 9).<br />
pict 9<br />
7. Adjustment<br />
MOUNTING / 21<br />
Check to make sure the boot meets international<br />
standards and is not damaged.<br />
Adjusting the forward pressure<br />
Don’t open the length adjustment lock as long as<br />
a ski boot is fixed in the binding.<br />
Open the heelpiece, place the ski boot in the toe<br />
cup and rest the boot heel on the brake<br />
treadle. Lift the length adjustment lock and slide<br />
the heel forward until the heel cup just touches<br />
the boot. Lock the length adjustment by pushing<br />
it down. Latch the boot in the binding and check<br />
forward pressure. The toe pincers should not be<br />
pressed open. Remove the boot and change the<br />
length adjustment if necessary.<br />
Adjusting the release values<br />
The release values of the toe and heel should<br />
be determined by height and body weight (ISO/<br />
ASTM) method. Set the binding accordingly with<br />
the adjustment screws. We recommend the use<br />
of a calibrated testing device and that you keep a<br />
written record of whether the system passes or<br />
fails (requirement in the US).<br />
Note: Release/retention settings above a release<br />
moment of 100 NM at the toe and 400 NM at the<br />
heel are higher than the international standards<br />
recommend and are used solely at the skier’s<br />
own risk!<br />
8. Function Check<br />
Entry / exit: Check to make sure that the boot<br />
does not catch on the heel hold down lug.<br />
Brake: press the brake treadle (1) down by hand<br />
(pict 10 and 11).<br />
pict 10<br />
●2<br />
❷1
Change language