Technical Manual 2005/06 - Tyrolia

20 / MOUNTING
Note: Keep in mind that some ski manufacturers
do not use the center of boot sole location
method. Always follow their instructions.
4. Drilling the holes
If not otherwise specified by the ski manufacturer,
use a 4,1 Ø x 9,0 mm drill bit. Use a 4,1 Ø x 7,0 mm
drill bit for skis that are shorter than 140 cm.
Drill the holes using the appropriate drill bit.
If required by the ski manufacturer, tap the hole
with a 12 AB tap. After drilling place a drop of
TYROLIA glue in each hole. It lubricates the
screws and seals the holes (pict 1).
pict 1
5. Mounting
For FREE FLEX PLUS:
Connect the two parts of the FREE FLEX-bridge.
The pins must face up and lock in the slots
(pict 2).
pict 2
Place the heel and the Free Flex band over the
prepared holes and fasten the four screws.
Note: For drill template positions up to 31 cm the
FREE FLEX-band cover has to be shortened. For
template positions 32 cm and up no shortening
is needed (pict 3).
pict 3
Connect the FREE FLEX-band cover (1) with the
toe base plate (2) at the position shown on the
drill template boot length indicator (see pict 4).
pict 4 ❷2 ❷1
Slide the connected parts into the heel plate (1)
until the mounting holes for the toe are aligned
with the prepared holes in the ski.
Connect the toe base plate with the FREE FLEXband
(see pict 5).
Place the toe over the holes and drive the screws.
Peel off the sticker which indicates the activation
of the Free Flex function. Turn the eccentric
screw (1) 180º clockwise as it is shown on the
sticker (see pict 6).
pict 6
❷1
pict 5
Turning the eccentric screw activates the Free
Flex Plus function. Always deactivate the Free
Flex Plus function before dismounting the binding.
For LD 12 CYBER:
Connect the LD CYBER bridge with the CYBER
toe base plate according to centimeter mark
from the drill template (pict 7).