Profibus System Integration PDF 4.03MB - Schneider Electric

PLC ConfigurationIn order to interact properly with the equipment, the PLC must understand the data itwill exchange with it.• For PTQPDMV1: create a Quantum UnityPro application with the PTQPDMV1module in the configuration, then import the XSY file generated by ProsoftConfiguration Builder. The application will set the variables for each device in theform of a data structure. The exchange of data between the CPU module andProfibus DP is through the bus to the PLC.• For PBY100: create a Premium UnityPro application with a PBY100 module in theconfiguration, then use UnityPro to import a CNF file generated by SyCon. ThePLC will use topological variables (IW% or% QW). The exchange of databetween the CPU and PBY100 module is through the bus to the controller.• For 5204-Mnet module: create an application with an Ethernet module thatsupports I/O scanning service in the UnityPro configuration, then select the zonesshared between the controller and module 5204-NET. The PLC data are locatedin % MW. The exchange of data between the CPU module and the 5204-Mnet isthrough the Ethernet network via the I/O scanning mechanism.Asset Management SoftwareThe asset management software can set the various devices connected on the busthrough the class II master bus. This can be a Profibus DP master module placed in arack, or a gateway controller that supports Ethernet TCPIP Modbus/Profibus .Personnal computerFDT Framework (e.g PACTware, FieldCare)Slave 1DTMSlave 2DTMMastercomDTMtechnologyDPV1 Class IIEthernet portSerial portEthernetProfibus PDV1Master moduleProfibus DPDP/PAcouplerot linkProfibus PASlave 1 Slave 257