GENERAL CATALOGUE - Urmet

WIRED INTRUSION ALARM SYSTEMS
1033/212
1033/042
INERTIAL CONTACTS
1033/272 Analogue processing board for sensors 1033/252
- Sensitivity adjustment
- Event counter setting
- Input for 4 wire + shield
- Alarm outputs with insulated C/NC contact for break-in alarm
- Power: from 11 to 15 Vdc
- Consumption: 40 mA
- Casing not included
- Dimensions: 64 (W) x 82 (H) x 15 (D) mm
1033/273 Analogue processing board for 1033/252 - 253 - 254
- Repeated event sensitivity adjustment (knocks)
- Single event sensitivity adjustable (break-in)
- Adjustable reset time from 1 second to 5 minutes
- Repeated events digital count programming
- Single event digital programming
- Input for 6 wire + shield (for 1033/253 sensor)
- Alarm outputs with insulated break-in tamperproof contact
- Power: 80 mA
- Casing not included
- Dimensions: 136 (W) x 92 (H) x 15 (D) mm
AID KIT
1033/212 Aid kit
The kit consists of a receiver and a remote control. It is capable of interfacing
with burglar alarms for managing aid requests (1061 and 1067 new line)
in connection with the new HA system mod. 1069.
- Operating mode selectable by means of jumper
- 12 Vdc power input
- Active alarm relay
- Flat battery output on remote control
- Alarm memory reset input from control unit
- Tamper output (casing opening protection)
- Remote control reception indication by means of buzzer
- Alarm memory state indication by means of LED (two-colour)
- Radio reception module 433 MHz
- Possibility of managing up to 4 remote controls
- Simple programming
1033/042 Aid remote control
Additional remote control for kit 1033/212.
• 235
WIRED INTRUSION
ALARM SYSTEMS