Edge Evolution Programmer Installation Instructions ... - Edge Products

Evolution06 LBZ & LLY Duramax2. Open the driver’s side door, and remove the access panel on the left sideof the dashboard (Figure #2). Pull the end of the ODBII cable outwards(shown in Figure #3). Remove two Torx screws using a #15 torx bit, andsnake the cable behind the panel with the vent, up to the A-pillar. Replacethe screws, and access panel. The cable will protrude from the dashboardup along the A-pillar and be able to move freely when pulled (Figure #4)Figure #2 Figure #3Figure #43. With roughly 8 to 10 inches of cable fed through the dashboard, set thePod onto the dashboard (shown in Figure #5) with the end of the cableprotruding through the front of the Pod. Remove the Dash Bezel bysliding your fingers behind it and pulling firmly toward the steeringwheel. Slide the tab on the bottom of the pod behind the bezel, and snapthe bezel back into place.15