150N Automatic Lifejacket with integral Deck Harness

More documents

Recommendations

Info

Re-arming and re-packing your lifejacket after inflation1341 33 g CO2 cylinder2 <strong>Automatic</strong> firing capsule3 United MouldersPro Sensor ® inflator4 Valve retaining nut5 Manual firing lanyard6 Activation indicator windowAll Green - ready to goRed - needs rearming562Examine the automatic capsule.Ensure that the cap is screwedhand tight onto the inflator.Check the components and assemble the inflator following these steps:1. Unscrew and remove the 33gCO2 gas cylinder from the inflatorand inspect its piercing cap. If it hasbeen pierced, replace it! (Fig.1).Fig. 113
Fig. 22. Make sure the manual lever is in theup and ready position. Install the CO2cylinder into the inflator by screwing ituntil hand-tight (Fig.2). Check that theautomatic capsule has not been fired byensuring that the bottom indicator isshowing green.Fig. 33. Check that the oral-inflation tubecap is in stowed position B (Fig.3).A Dust cap in deflate positionB Dust cap in stowed positionABFig. 44. Ensure the cord runs freelyfrom the firing head to theeyelet in the cover. Re-fastenthe zipper. If everythingconforms to the precedinginstructions, your lifejacketis ready for use. Re-run thezip back around the cover toclose (Fig.4).14
Page 1 and 2: 150N Automatic Lifejacket withinteg
Page 3 and 4: features1.2.3.4.5.6.7.8.9.10.Automa
Page 5 and 6: Tightening / looseningThreading buc
Page 7 and 8: Lifejacket inflation: UML Pro Senso
Page 9 and 10: 2. Concertina bladder onto itself e
Page 11 and 12: Inflating your lifejacketIt is reco
Page 13: Testing your lifejacketYou should a
Page 17 and 18: CHEMICALSAll chemicals, (including
Page 19 and 20: (EN) Model :(F) Modèle :(D) Modell

150N Automatic Lifejacket with integral Deck Harness

Create successful ePaper yourself

Delete template?

Save as template?