150N Automatic Lifejacket with integral Deck Harness

More documents

Recommendations

Info

ContentsPage no:Introduction 9Approval conditions 9Inflating and deflating your lifejacket 10Maintaining your Deckvest 11Testing your lifejacket 12Re-arming and re-packing your lifejacket 13-14Instructions for use 15-17Inspection record sheet 18Spinlock DeckvestThis Deckvest is an integrated lifejacket and harness approved to ISO 12402-3 (150N).It is important to get into the habit of wearing Deckvest. It is comfortable, safe anda pleasure to wear.A lifejacket or harness only works if it is fitted and secured correctly.Inflatable lifejackets only become buoyant when inflated: they contain no inherentlybuoyant materials.As user, it is your personal responsibility to understand the operation and maintenancerequirements of your inflatable lifejacket and be familiar with its limitations.Approval conditions:This Deckvest is an integrated CE approved lifejacket according to ISO 12402-3(150N) and a CE approved Deck harness according to ISO 12401.9
Inflating your lifejacketIt is recommended that the following inflation procedures are followed:1. MANUAL INFLATIONTo manually inflate the lifejacket, sharply pull the rubber handle downwards.The CO2 gas cylinder should inflate the bladder within seconds.2. ORAL INFLATIONTo inflate the lifejacket by mouth, locate the oral inflation tube by opening thezip at the yellow breakout point on the front panel of the lifejacket. Then afterremoving the end cap, blow into the tube until the lifejacket is fully inflated.3. AUTOMATIC INFLATIONInflation should occur automatically within seconds of the inflator beingsubmerged. The automatic capsule is designed to activate the sprung pinto puncture the CO2 cylinder and inflate the bladder.CO2 Cylinder sizeModel 150N: use 33gINFORMATION: PRESSURE VARIANCEWith variations in air or water temperatures, topping up by oral inflation maybe required to maintain full buoyancy-especially after prolonged immersion.Deflating the lifejacketTo deflate the lifejacket, invert the oral-inflation tube end cap and insert it into thevalve. Holding the cap firmly in this position, gently squeeze the lifejacket until allair or gas has been expelled. Return the cap to its normal position.Usage below freezingWhen the temperature is below freezing, even a fully charged cylinder may notadequately inflate your lifejacket. Do not use your lifejacket under these conditionsunless it has been partially inflated by mouth.WARNING: Using the CO2 inflation when your jacket is already fullyinflated can over-pressurise and damage your lifejacket.10
Page 1 and 2: 150N Automatic Lifejacket withinteg
Page 3 and 4: features1.2.3.4.5.6.7.8.9.10.Automa
Page 5 and 6: Tightening / looseningThreading buc
Page 7 and 8: Lifejacket inflation: UML Pro Senso
Page 9: 2. Concertina bladder onto itself e
Page 13 and 14: Testing your lifejacketYou should a
Page 15 and 16: Fig. 22. Make sure the manual lever
Page 17 and 18: CHEMICALSAll chemicals, (including
Page 19 and 20: (EN) Model :(F) Modèle :(D) Modell

150N Automatic Lifejacket with integral Deck Harness

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?