Contents - Peavey.com

Compressor ccn)The Compressor effect suppresses high input levels while boosting small signal levels as the input decreases.The net result is a more consistent output volume and increased sustain.1 --,I Peak Detect 1~Input N -NoiseGateCompressor L -(Sustain)(Level)1.outputParametersAh%.- The Atk (Attack) parameter adjusts the speed at which the compressor responds to increasesin signal level. Kang:e is from X Slow to X Fast.Rd The Rel (Release) parameter adjusts the time for the output signal to decay. Range is fromX Slow to X Fast. Setting the release to X Fast results in a very rapid decay, while setting the releaseto X Slow results in a very slow decay.521s: The Sus (Sustain) parameter provides seven levels of sustain to vary the maximum amount of gainthat can be achieved by the compressor at small signal levels. Range is O-6.Lw: The Lev (Level) parameter adjusts the maximum output of the compreS.sor. Range is 0400%.N$27 At low signal levels, a compressor’s gain mzty be very high, thus raising the level of noise outputwith no signal present. The Ngt (Noise Gate Threshold) parameter provides ten levels of noisesuppression on the output. Range is l-10.Distortion (IDS)The Distortion effect consists of a digital distortion followed by an equalizer section. This is a mono effect.ParametersLkPS:Ft.EdBd:The Dr (Drive) parameter- controls the amount of distortion by pre-filtering and boosting the inputsignal. Range is O-100.The Ps (Post Gain) parameter is used to reduce the signal level to prevent overdriving the EQsection of the effect. Range is 0- 100.The Ft (Fat) parameter controls the low frequency gain. Parameter range &50.The Ed (Edge) parameter controls the high frequency gain. Range is *SO.The Bd (Body) parameter controls the mid fbquency gain. Range is *SO.A-4 Appendix A individual Effects