Contents - Peavey.com

THE FIRST T/ME YOU TURN IT ON (RE/NlTlAL/ZATION)This procedure is recommended the first time your Tube Fex is turned on after purchase from your Peaveydealer. This ensures that the memory is initialized and that the battery is fully charged.WARNING!Z3efollowingp~ocedu~e will overwrite all changes made to the unit’s memo y storuge, yeplacing them withfacto y settings. Only peeom the following if you desire to re-initialize the unit.- _1. While holding both the v (down /dec arrow) and rig& arrow buttons on the front panel, power upthe unit by hirning on the power switch.The unit has now been initialized to factory settings. It is recommended that you leave the unit turned onfor at least three hours at this time to ensure the battery has a full charge. The unit’s battery should then lastseveral years before replacement is required. The unit will warn you when the battery is getting low.Battery replacement must be performed at an authorized Peavey Service Center.Adjusting The Global Input And Output Levels, and Global EQ(Very Important)Once the connections are all made, set up the input and output levels of the Tube Fex as follows:Turn on the Tube Fex and press the Global button until you get to the [GLOBI display; set all level controlsto 0: input level knob on the front of the Tube Fex, output level knob on the front of the Tube Fex, and theinput level control on your power amp (if it has one).Adjust the input level control on the front of the Tube Fex while playing your instrument. The level shouldbe set so that the Active/Clip LED just begins to turn red on your absolute loudest playing level.Then turn on your power amp. Set the input level control on the amplifier to your normal playing level. Nosound will be heard from it yet.Finally, slowly adjust the output level control on the front of the Tube Fex while playing until a suitableplaying level is reached.Set the Bass, Mid and Treble levels to taste. These settings are global. This is a very handy feature. Forexample: If you develop your effects at home and then go to a live stage and notice that there is notenough high end in that particular room/stage, all you must do is go to the [GLOBI display and adjustthe Treble (to taste). This will affect all of your patches.16 Chapter 7 Setup