CANICOM 800 technical support - Num'Axes

Renew the radio coding between collar and remote control.CANICOM 800 technical supportRadio coding enables the transmitter (remote control) to work with the receiver (collar).If you have two collars, you have to re-code them one at a time.To code the remote control with the collar once again, proceed as follows: Switch on the remote control using the button located on the left side.The receiver collar must be switched off (indicator light off).Press the A or B selection key on the remote control in order to select the collar youwant to code: dog A: black strap – dog B: yellow strap – the letter A or B will appearon the LCD screen.Move the remote control towards the collar so that the magnet position indicator onthe remote control comes into contact with the red mark on the collar, hold for 6seconds (see diagram below). The indicator light on the collar lights in fixed greenthen flashes in red.Move the remote control away from the collar. Press the button of the remote control. A beep sound is emitted; the collar issynchronized with the remote control.Place these two areastogether for 6 secondsIf you have a 2 nd collar, renew the sameprocedure.The receiver collars can be re-codedindefinitely, either with the same remotecontrol, or with a new one from theCANICOM range.Re-initialize the collar (reset).To re-initialize the collar proceed as follows: Unscrew the 4 screws of the battery cover andremove the battery from its housing. With a metallic tool (e.g. scissors), connect the 2battery supports for approximately 2 seconds.Insert the battery once again (one beep sound mustbe emitted indicating the correct installation of thebattery). Test the product with the neon test lamp (seeparagraph “Check the product operates correctly”).Reset:connect the 2battery supportswww.numaxes.com 3/5