af 200 ing - Benassi
af 200 ing - Benassi af 200 ing - Benassi
S.p.A. AF 200-Pic. n°8--Pic. n°9-OPERATING AND REGULATING THE MACHINE• Before starting to use the leaf-sucker check the fixing of the suction opening.• Check the fixing of the bag and that the bag is not torn.• The machine moves forward by pulling the lever “G” Pic.9.• If the clutch slips or the lever is too hard to be pulled, you can regulate the clutch wire through the adjuster Ref. “H”Pic.9;• When the vac-bag is full or very heavy, go next to the unloading area, switch off the engine, open the zipper at theback of the bag (see Pic.10) and empty it. It is also possible to uncouple the bag from the handlebar by lifting the twohands with hole from the pins (Ref. “I” Pic.9), and loosening the belt .• The height of the suction opening can be regulated easily through the knob (Ref. ”L” Pic.11.). The height van vary from2 to 11 cm. from the ground, and it depends on the material that must be sucked.• You can fix an accessory consisting of a flexible pipe ending with a stiff piece of pipe with knob (Pic.12.) if suckingmust be carried out in narrow places inaccessible to the leaf sucker.• You can fix this accessory by loosening the knob that fastens the opening (ref. “P” - pic.3), taking away the openingof the central body and fitting the flexible section pipe. Pay attention that the plate presses the button of themicroswitch and screw the knob again.• You can use the machine as a blower too (pic. 13) by means of an accessory that allows you to blow leaves,wastepaper, etc., towards narrow areas such as the roadside to collect them afterwards.• Loosen the four screws that fix the unloading pipe (ref. Q - pic.4) and take the pipe away after having completelyremoved the bag as described above.• Loosen the three screws at the back of the central body where you can find the engine bearing flange (ref. R - pic.4)and turn of 120° by placing the central body as in picture 13, then reinsert the three screws and tighten them.• Place the blowing opening at the end of the central body (ref. O - pic. 13) and fix by means of the four screws that willbe needed for the pipe.• Pay attention to the cable of the microswitch by rotating the central body.IMPORTANT ! ! !IF THE LEAF-SUCKER IS USED IN VERY DUSTY PLACES IT MUST BEPERIODICALLY CLEANED BY REMOVING THE DUST. THE OBSTRUCTION OF THEBAG DUE TO THE DUST CAN CAUSE ITS BREAKING. DO NOT ASSEMBLE THE BAGIF IT IS WET. CARRY OUT THE OPERATION ONLY WHEN THE ENGINE ISSWITCHED OFF.6
S.p.A. AF 200-Pic. n°10--Pic. n°11-MAINTENANCE• For changing the oil and other maintenance operations on the engine(spark plugs, air filter, regulations), refer to the enginemanual provided.• Clean periodically the bag from the dust. Do not assemble the bag if it is wet-Pic. n°12--Pic. n°13-WARRANTYThe machines and accessories are guaranteed for 12 months, with the exception of electrical parts or parts in rubber. Themanufacturer shall replace pieces recognised as defective free of charge. Labour and transport shall be at the expense of thepurchaser. The warranty doesn’t apply if the guaranteed parts are defective due to wrong installation, tempering inaccurate useor carelessness. Warranty request must be made through dealers authorised by the manufacturer.With regard to materials not of our manufacture, with special reference to the motor, the rules laid down by the respectivemanufacturers shall apply. Any request for repair shall therefore be directed to the specific service centres in the respectiveareas.For any problems or repair, contact the dealer where the machine was purchased.SAFETY TESTS AND CERTIFICATION7
- Page 1 and 2: S.p.A.OPERATION ANDMAINTENANCE MANU
- Page 3 and 4: S.p.A. AF 200IDENTIFICATION AND TEC
- Page 5: S.p.A. AF 200• Always add fuel to
S.p.A. AF <strong>200</strong>-Pic. n°10--Pic. n°11-MAINTENANCE• For chang<strong>ing</strong> the oil and other maintenance operations on the engine(spark plugs, air filter, regulations), refer to the enginemanual provided.• Clean periodically the bag from the dust. Do not assemble the bag if it is wet-Pic. n°12--Pic. n°13-WARRANTYThe machines and accessories are guaranteed for 12 months, with the exception of electrical parts or parts in rubber. Themanufacturer shall replace pieces recognised as defective free of charge. Labour and transport shall be at the expense of thepurchaser. The warranty doesn’t apply if the guaranteed parts are defective due to wrong installation, temper<strong>ing</strong> inaccurate useor carelessness. Warranty request must be made through dealers authorised by the manufacturer.With regard to materials not of our manufacture, with special reference to the motor, the rules laid down by the respectivemanufacturers shall apply. Any request for repair shall therefore be directed to the specific service centres in the respectiveareas.For any problems or repair, contact the dealer where the machine was purchased.SAFETY TESTS AND CERTIFICATION7
Change language