You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
S.p.A. AF <strong>200</strong>-Pic. n°8--Pic. n°9-OPERATING AND REGULATING THE MACHINE• Before start<strong>ing</strong> to use the le<strong>af</strong>-sucker check the fix<strong>ing</strong> of the suction open<strong>ing</strong>.• Check the fix<strong>ing</strong> of the bag and that the bag is not torn.• The machine moves forward by pull<strong>ing</strong> the lever “G” Pic.9.• If the clutch slips or the lever is too hard to be pulled, you can regulate the clutch wire through the adjuster Ref. “H”Pic.9;• When the vac-bag is full or very heavy, go next to the unload<strong>ing</strong> area, switch off the engine, open the zipper at theback of the bag (see Pic.10) and empty it. It is also possible to uncouple the bag from the handlebar by lift<strong>ing</strong> the twohands with hole from the pins (Ref. “I” Pic.9), and loosen<strong>ing</strong> the belt .• The height of the suction open<strong>ing</strong> can be regulated easily through the knob (Ref. ”L” Pic.11.). The height van vary from2 to 11 cm. from the ground, and it depends on the material that must be sucked.• You can fix an accessory consist<strong>ing</strong> of a flexible pipe end<strong>ing</strong> with a stiff piece of pipe with knob (Pic.12.) if suck<strong>ing</strong>must be carried out in narrow places inaccessible to the le<strong>af</strong> sucker.• You can fix this accessory by loosen<strong>ing</strong> the knob that fastens the open<strong>ing</strong> (ref. “P” - pic.3), tak<strong>ing</strong> away the open<strong>ing</strong>of the central body and fitt<strong>ing</strong> the flexible section pipe. Pay attention that the plate presses the button of themicroswitch and screw the knob again.• You can use the machine as a blower too (pic. 13) by means of an accessory that allows you to blow leaves,wastepaper, etc., towards narrow areas such as the roadside to collect them <strong>af</strong>terwards.• Loosen the four screws that fix the unload<strong>ing</strong> pipe (ref. Q - pic.4) and take the pipe away <strong>af</strong>ter hav<strong>ing</strong> completelyremoved the bag as described above.• Loosen the three screws at the back of the central body where you can find the engine bear<strong>ing</strong> flange (ref. R - pic.4)and turn of 120° by plac<strong>ing</strong> the central body as in picture 13, then reinsert the three screws and tighten them.• Place the blow<strong>ing</strong> open<strong>ing</strong> at the end of the central body (ref. O - pic. 13) and fix by means of the four screws that willbe needed for the pipe.• Pay attention to the cable of the microswitch by rotat<strong>ing</strong> the central body.IMPORTANT ! ! !IF THE LEAF-SUCKER IS USED IN VERY DUSTY PLACES IT MUST BEPERIODICALLY CLEANED BY REMOVING THE DUST. THE OBSTRUCTION OF THEBAG DUE TO THE DUST CAN CAUSE ITS BREAKING. DO NOT ASSEMBLE THE BAGIF IT IS WET. CARRY OUT THE OPERATION ONLY WHEN THE ENGINE ISSWITCHED OFF.6
Change language