PLAXIS LIQUEFACTION MODEL UBC3D-PLM - Knowledge Base

More documents

Recommendations

Info

Figure 3.6: Comparison of the predicted evolution of excess pore pressureby the modified <strong>UBC3D</strong>-<strong>PLM</strong> with the experimental results of a dynamiccentrifuge. Point a: Deactivation of the secondary yield surface. Point b:Dilatancy prediction.Figure 3.7: Reproduced stress path in a p ′ − q stress space during the numericalmodelling of the dynamic centrifuge. Stress point at 24.8 m depth.Point a: Primary yield surface is used. Point b: Deactivation of the secondaryyield surface.42
Figure 3.8: Reproduced stress path in a p ′ − q stress space during the numericalmodelling of the dynamic centrifuge. Stress point at 30.8 m depth.Point a: The primary yield surface is used. Point b: Densification rule.Point c: The primary yield surface is used. Point d: Soil densification.Point e: Deactivation of the secondary yield surface.43
Page 1: PLAXIS LIQUEFACTION MODELUBC3D-PLMA
Page 5 and 6: 3.6 Reproduced stress path in p ′
Page 7 and 8: AbstractIn this report the formulat
Page 9 and 10: Comparing with the previous version
Page 11 and 12: Figure 1.2: Projection of the yield
Page 13 and 14: ( ) mepK = KBP e A (1.9)P ref( ) ne
Page 15 and 16: The plastic potential function is f
Page 17 and 18: the secondary loading in order to e
Page 19 and 20: loading surface is used again. A ne
Page 21 and 22: The drained bulk modulus of the soi
Page 23 and 24: modelling the inherent and induced
Page 25 and 26: Table 1.1: Input Parameters for the
Page 27 and 28: whereas the P P RMAX can reveal if
Page 29 and 30: Chapter 2Validation of the UBC3D in
Page 31 and 32: Pore Pressure, u (kPa)UBC3DEx.Pore.
Page 33 and 34: first cycle of post-liquefaction be
Page 35 and 36: Shear Stress , τ (kPa)1086420-2-4-
Page 37 and 38: 1.2Excess Pore Pressures\nitial Ver
Page 39 and 40: Chapter 3Validation of theUBC3D-PLM
Page 41 and 42: Figure 3.2: The finite element mesh
Page 43 and 44: checked but the results are not fur
Page 45 and 46: used again when the stress path exc
Page 47: EPP (kPa)EPP (kPa)EPP (kPa)Measurem
Page 51: S.S. Park and P.M. Byrne. Practical

PLAXIS LIQUEFACTION MODEL UBC3D-PLM - Knowledge Base

Create successful ePaper yourself

Delete template?

Save as template?