F3Dn Service Manual Parts Replacement / Section 2.2 ... - FFSNorge

More documents

Recommendations

Info

F3Dn Service Manual Parts Replacement / Section 2.19Main Control Board ChipReplacement Photos Continued…[Part No. 18000812][Photo 7][Photo 4]Note semi-circular notch on one end of chip. Thismust align with the notch on the saddle. (The notch isnot white – it is shown white for illustration purposes.Chip version number is printed on white label.)Gently pry the chip from the saddle.[Photo 8][Photo 5]Once the chip is loose, it can be pulled straight out.Carefully insert the new chip into saddle, making surethat notches align and that all pins align withcorresponding slots.[Photo 6]Chip saddle with the chip removed. Note the semicircularnotch on the left aligns with a similar notch onthe chip.For Technical Support, Call 800-537-2653.Copyright Ó 2006 Franke, Inc. All rights reserved.
F3Dn Service Manual Parts Replacement / Section 2.202.20 Hopper Rotor Replacement[Part No. 19000246]1) The F3Dn Dispenser should be OFF and the freezercompartment fully defrosted before proceeding.2) Open freezer door and remove the Hopper in question.Place it on its side, with the bottom rectangular openingfor the rotor facing up.3) Inspect rotor for damage or excessive wear. If the rotordoes not turn easily by hand, it may need to be replaced.4) The rotor front can be identified by the manual rotorhandle molded into the rotation axle. The back supportaxle doesn’t have this handle.5) Remove the old rotor by gently prying out the plasticHopper side closest to the manual rotation handle. Whenthat handle clears the hole in the Hopper, pry out therear side of hopper so that hub clears that hole. Pull upand carefully remove the rotor from the hopper.6) Install the new Rotor [P/N 19000246] by reversing thisprocess. Make sure the rotor end with the manualrotation handle faces the front of the Fry Hopper.7) Test the replacement Rotor by:8) Manually turn or spin the Rotor Handle. The rotor shouldrevolve easily, with little resistance.[Photo 1]A finned rotor is mounted insideeach Hopper to gently movefrozen fries to the ProductChute.[Photo 2]When removing the Rotor, use alarge screwdriver or flat pry barto gently lever the sides of theHopper enough free to the rotor.9) Replace the Hopper in the freezer compartment andreturn the unit to service.‣Rev. 1 6/06For Technical Support, Call 800-537-2653.Copyright Ó 2006 Franke, Inc. All rights reserved.
Page 2 and 3: F3Dn Service Manual Parts Replaceme
Page 6 and 7: F3Dn Service Manual Motor Test / Se

F3Dn Service Manual Parts Replacement / Section 2.2 ... - FFSNorge

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?