PMI Piranha G2 Manual - Paintball Solutions

TRIGGER AND SHOOTINGTrigger will not pull backTrigger pulls back, marker will not shootTrigger action does not feel smoothMarker runs on (partially cycles more thanCheck that mechanical safety is not engaged; safety shouldbe fully pushed toward left side of marker and red o-ringon safety should be fully visibleCheck that marker is cocked, air source is correctlyattached, and air source is adequately filledCheck pin at top of trigger near trigger frame; if it catches on the edge of the frame, use center punch to tap pinback into placeCheck that air source is correctly attached and air sourceis once when trigger is squeezed) adequately filled. Checksear for wear. Check hammer o-ringfor wear and replace hammer o-ring if needed, using factoryo-ring only. Use of other than factory o-ring cancause run on.VELOCITYLowLowLowLowHighHighAdjust using velocity adjusterCheck that air source is adequately filledRemove bolt/hammer assembly and clean it; clean insidereceiver area where bolt/hammer assembly is locatedChange to a stiffer hammer springAdjust using velocity adjusterChange to a less stiff hammer springCHRONOGRAPH THE MARKER AT REGULAR INTERVALS DURING THE DAY, AS WELL AS ANY TIME THE POWERSOURCE IS REFILLED OR CHANGED, ANY TIME THE BARREL OR ANY PART IN THE POWER SYSTEM IS CHANGED,AND UPON REQUEST OF ANY PLAYER OR GAME OFFICIAL.DO NOT EXCEED 300 FPS VELOCITY.PMI Piranha 22