PMI Piranha G2 Manual - Paintball Solutions

More documents

Recommendations

Info

4. To remove the ASA adapter, remove the small allen screw under the receiver. Figure 30. The ASA adaptercan then be removed. Figure 31. NOTE: The o-ring on the ASA adapter that, at insertion, contacts thereceiver first is white. Theother o-ring is black.Figure 30 Figure 315. To access the valve assembly, remove the the valve spring, pin, and guide as in Figure 32. Remove thesmall brass screw located in the center of the underside of the receiver, Figure 33. To remove the valvebody, use a flat ended wooden dowel to push the valve body out of the front the receiver, Figure 34.Figure 32 Figure 33 Figure 34The valve body must be inserted correctly: note that the hole to the rear of the valve is tapered, and hasa black o-ring. The front of the valve is not tapered and has a white urethane o-ring. The valve pinassembly must be inserted correctly; valve pin must drop down into valve body completely.Valve springmust be centered in valve bore.6. Follow the procedures in this manual for adding power system, loader, and paintballs.Questions about the operation of the PMI Piranha paintball marker may be directed to: PursuitMarketing, Inc., 5035 River Road, Schiller Park, IL 60176 USA ; phone 847.233.9900 ext. 7150 www.pminetwork.comPMI Piranha 20
TROUBLESHOOTINGWARNINGDO NOT ATTEMPT TO PERFORM MAINTENANCE PROCEDURES UNLESS QUALIFIED TO DO SO.THIS TROUBLESHOOTING GUIDE DOES NOT COVER ALL SITUATIONS AN INDIVIDUAL MAY ENCOUNTER. CONTACT PMI, INC.,FOR REPAIR ASSISTANCE AND INFORMATION REGARDING AUTHORIZED PMI PIRANHA REPAIR FACILITIES.PAINTBALL MARKER POWER SYSTEMS MUST BE REPAIRED OR REPLACED WITH THE CORRECTPRESSURE RATED COMPONENTS.AIR LEAKLeak in pressure source between valve and cylinderLeaks when power system is aired upLeaks at connection between ASA and tankDo not fill cylinder. Immediately take to qualifiedpersonnel for inspection. Cylinder must be drained.Cock marker before powering up system.Check o-ring at connection or on remote hose connectorLeaks at connection between braided air hose and fitting Requires disassembly of air hose assembly for repairs;contact factory or factory authorized repair centerLeaks at body of marker or down the barrelLeaks at connection betweengas-through foregrip & vertical ASARequires removal of valve and check of valve o-ringsRemove foregrip unit and check o-ringWARNINGBEFORE DISASSEMBLY OF THE MARKER, REMOVE ALL PAINTBALLS FROM THE MARKER, BARREL, AND LOADER;REMOVE POWER SOURCE; AND REMOVE ALL GAS OR AIR FROM THE POWER SYSTEM.PMI Piranha 21
Page 1 and 2: PMI PIRANHA OWNER’S MANUALWARNING
Page 3 and 4: All paintball markers must be chron
Page 5 and 6: 8. Before attaching power source, r
Page 7 and 8: WARNINGA COMPRESSED GAS OR AIR CYLI
Page 9 and 10: The hammer spring assembled with th
Page 11 and 12: PMI PIRANHA PARTS LOCATIONBarrelPow
Page 13 and 14: Figure 9Shown: PMI Piranha VTLVerti
Page 15 and 16: MAINTENANCE OF THE PMI PIRANHAThe P
Page 17 and 18: MAINTENANCE OF THE PMI PIRANHAREASS
Page 19: ADVANCED MAINTENANCE PROCEDURESWARN
Page 23 and 24: TROUBLESHOOTINGPAINTBALLSNot flying
Page 25: REPAIR PROCEDUREORIGINAL SALES PURC

PMI Piranha G2 Manual - Paintball Solutions

Create successful ePaper yourself

Delete template?

Save as template?