PMI Piranha G2 Manual - Paintball Solutions

More documents

Recommendations

Info

SEQUENCE FOR BOLT/HAMMER REASSEMBLYFigure 15 Figure 16Figure 17Figure 18 Figure 19 Figure 20Figure 21Figure 22 Figure 23Figure 24 Figure 25 Figure 26PMI Piranha 18
ADVANCED MAINTENANCE PROCEDURESWARNINGDO NOT ATTEMPT TO PERFORM MAINTENANCE PROCEDURES UNLESS QUALIFIED TO DO SO.CONTACT PMI, INC., FOR REPAIR ASSISTANCE AND INFORMATION REGARDING AUTHORIZED PMI PIRANHAREPAIR FACILITIES.PAINTBALL MARKER POWER SYSTEMS MUST BE REPAIRED OR REPLACED ONLY WITH THE CORRECTPRESSURE RATED COMPONENTS.1. Before disassembly of the marker, remove all paintballs from the marker, barrel, and loader; remove powersource; and remove all gas or air from the power system.2. To remove the bottom line air system (if needed), detach the bottom line ASA from the grip by removing thetwo screws. Figure 27. Then unscrew the threaded connector from the vertical ASA adapter. Figure 28Bottomline ASAGripVertical ASA AdapterThreaded ConnectorFigure 27 Figure 283. To removetrigger frame from the receiver, remove the two largeallen screws under the receiver. One is in front of the trigger guardand one is behind the grip portion of the frame. Figure 29. ThePMI Piranha 19receiver then will disassemble from the triggerframe.LargeAllen ScrewFigure 29LargeAllen Screw
Page 1 and 2: PMI PIRANHA OWNER’S MANUALWARNING
Page 3 and 4: All paintball markers must be chron
Page 5 and 6: 8. Before attaching power source, r
Page 7 and 8: WARNINGA COMPRESSED GAS OR AIR CYLI
Page 9 and 10: The hammer spring assembled with th
Page 11 and 12: PMI PIRANHA PARTS LOCATIONBarrelPow
Page 13 and 14: Figure 9Shown: PMI Piranha VTLVerti
Page 15 and 16: MAINTENANCE OF THE PMI PIRANHAThe P
Page 17: MAINTENANCE OF THE PMI PIRANHAREASS
Page 21 and 22: TROUBLESHOOTINGWARNINGDO NOT ATTEMP
Page 23 and 24: TROUBLESHOOTINGPAINTBALLSNot flying
Page 25: REPAIR PROCEDUREORIGINAL SALES PURC

PMI Piranha G2 Manual - Paintball Solutions

Create successful ePaper yourself

Delete template?

Save as template?