Gasifier Experimenters Kit

Gasifier Experimenters KitFan Kit:Raw sheetmetal pieces,no motor, $49Raw sheetmetal pieces,motor included, $79Welded sheetmetal,no motor, $99Welded sheetmetal,motor included, $129The vac/blower is a long-standing difficulty for the DIY gasifier builder. There is no good equivalent from otherindustries that shows up as obtainium. Thus we built one and now offer the same to you in a variety of states ofassembly.This vac/blower kit is a proper high rpm centrifugal fan that will generate the needed 5-10 inches of h20 vacuum(a typical squirrel cage will only generate 1" of h20 vac). All metal construction will take the heat. No moremelting shop vacs and/or mom's hairdryer. The motor shaft is well protected and sealed to avoid tar fouling.The intake is 3" in diamter. The output is a 2" sch 40 pipe nipple, threaded. The rotor is 7.5" in diameter, with a5/16" shaft collar to accept the motor. The internals are configured so that gas can pass through the fan housingwithout constriction when the fan is not running. Thus you can put it inline with your gas piping and avoid theseparate valved branch circuit. See more detailed pictures in the gallery.The optional motor is a 12vdc three speed motor (2800, 4000 and 7500rpm).Cyclone Kit:Rolled sheetmetal pieces,no welding, $79Welded and painted, $149This is the standard 5" diameter cyclone from the GEK kit. It comes with a 2" box flange attachment at the inlet,and a 2" threaded NPT nipple for the outlet. A glass Mason jar and adapter is included for theparticulate/condensate/tar catch.(Note: picture has 2" NPT nipple with union at the inlet. This method was replaced at v2.0 with a squaresheetmetal tube and flange plate. No picture yet.)PaymentOrders can be placed using the "buy now" buttons above, or via check to:ALL Power Labs1010 Murray StreetBerkeley, CA 94710http://www.allpowerlabs.org/gasification/gek/purchase.html (5 of 6) [10/9/2008 08:00:29]