Cellcorder CRT-400 Quick Start Instructions - Alber

More documents

Recommendations

Info

Powering Off the Cellcorder1. Press and hold the green Power Key. 2. Powering off doesn’t automatically deletevoltage or resistance readings from memory.Power3. If readings are in memory, you are promptedto save them.Taking Voltage Readings1. Connect the voltage probes to the Cellcorderand select Test Mode/F1.WarningDon't measure voltages greater than 20V DC.2. From the Test Mode menu, selectF1-Voltage.4. If "Stored in Memory" appears, retest thecell or change the cell number by typing anumber and pressing Enter.3. If "Resume Test" appears, put the probeson the cell.5. When the unit beeps, remove the probes.The cell number advances automaticallyto the next cell.
CRT-400 Cell Resistance TesterThe Cellcorder is also a Digital Voltmeter (DVM)1. In the voltage mode, select DVM by pressingthe F1 button.2. The screen displays the measured voltages.3. Readings are not saved in DVM mode.Taking Resistance Radings1. Connect the resistance test leads to theCellcorder and select Test Mode/F1.2. From the Test menu, select F2-Resistance.3. Select the Amp Hour rate/F2 of the cellbeing tested. Specify the number ofIntercell connections/F3 per cell.No VFloat Readings Exist.Now What?If "No VFloat readings exist. Are you sureyou want to continue?” appears. ChooseNo/F2, read voltage, then resume resistancetesting. Reading voltage before resistanceresults in more accurate voltage readingsbecause skewing is not a factor. If youchoose Yes/F1, voltage and resistance areread concurrently. Concurrent readings aresubject to the skewing effect.5. Connect the leads to the cell. See lower-leftfor some examples; refer to the CRT-400 User’sGuide for more details. Press the orange Testbutton. The display shows test progress.4. Select Test/F1.VoltageInternal CellResistanceUp to 4Intercell Readings(mem) VoltageReadings Storedin Memory(act) ActualVoltage Reading6. When the unit beeps, remove the probes.When leads are moved, the cell numberadvances automatically to the next cell.7. When finished testing, press the Done/F4button.
Page 1: CRT-400 Cell Resistance TesterPower
Page 5 and 6: Transferring Specific Gravityand Te
Page 7 and 8: Files Used by the CRT-400 Cellcorde
Page 9 and 10: CRT-400 Cell Resistance TesterViewi
Page 11 and 12: Trending a Parameter Over TimeTrend

Cellcorder CRT-400 Quick Start Instructions - Alber

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?