IBM Tivoli NetView for z/OS Programming: Pipes - IBM notice

PIPE XCFTABLE
PIPE XCFTABLE
Syntax
XCFTABLE:
XCFTABLE MEMBER
STATFLD
USERDAT
► group_name. member_name
plex_name.
label_name.plex_name.
Command Description
The XCFTABLE stage retrieves and sets the following data:
v state field maintained by the z/OS XCF service for a group member
v user data field maintained by the NetView program for the group member
v table entry for the member
Streams
274 Programming: Pipes
Usage Note: This stage is used internally by the NetView program; use this stage
only to set data for user–defined groups with the USERDAT or
STATFLD options.
Stream Type Number Supported
Input 1
Output 1
Termination Conditions
The XCFTABLE stage terminates when either its input stream or output stream
disconnects.
Operand Descriptions
MEMBER
Specifies the member for the actual table entry.
STATFLD
Specifies the state field.
USERDAT
Specifies the user data field.
label_name
For members not in the local NetView's sysplex (which is the case at an
enterprise master), specify the label used on the ENT.SYSTEMS statement that
established contact with the remote member's XCF group. This can be specified
as a wildcard of an asterisk (*), which matches any label. This operand is not
needed for members within the local NetView's sysplex
plex_name
For members not in the local NetView's sysplex (which is the case at an
enterprise master), specify the name of the sysplex in which the remote system
►