IBM Tivoli NetView for z/OS Programming: Pipes - IBM notice

|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
PIPE REVISRPT
Syntax
REVISRPT:
REVISRPT
Command Description
The REVISRPT stage command creates a report of the action of the active revision
table for a simulated message.
The input message is submitted to the active revision for simulated revision. The
simulation is not perfect because of the following reasons:
v Some WQE fields from the original message are not recorded in the NetView
message AIFR.
v Other message alterations from MPF and other subsystem operations are not
reproduced. The simulation also ignores the NETVONLY action of the revision
table.
The revised message is written to the primary output stream. If connected, the
secondary output stream receives a BNH informational message, reporting the
conditions satisfied by the simulated message.
Termination Conditions
The REVISRPT stage command ends when either its primary input or primary
output stage disconnects; a secondary output stream is optional.
Usage Notes
PIPE REVISRPT
1. The REVISRPT stage cannot be a first stage.
2. Processing of the REVISRPT stage occurs asynchronously. Therefore, use the
CORRWAIT stage to allow the results to be processed by subsequent pipe
stages.
Chapter 2. Pipeline Stages and Syntax 203