Building Drawings Checklist: Architectural Drawings - National ...

7.7 Dimensidn the height and sill locations of all window and dooropenings.7-8 Call up all window and door types on elevations by codelet ters/numbers.7.9 Show any metal louvres and refer to the mechanical drawings.7.10 Indicate the metal flashing (roof) and masonry coping, if any.7.11 Show the roof ladders, and refer to detafl.7.12 Show any skylights, chimneys and other parts of constructionappearing behind the elevation plane.7.13 Show the exterior light fixtures, mailboxes, etc., to be installed,7.14 Indicate the location and size of exterior signs, if any.8. LONGITUDINAL AND CROSS-SECTIONS8.1 These drawings should be reexamined for accuracy a£ &nfonaatfonafter the roof finish and door schedules have been completed, 'Lt isnot advisable to show the pictorial elevation of the walls beyondthe section plane.8.2 Indicate the approximate existing grade along the line where thesection is taken,8.3 Indicate the finish grade elevation and tkte grade finash adjacent tothe building (paving, grass, etc.)8.4 Indicate the elevation of all the floors, the roof slabs, the topsof the foundation, the roof ridge and the slope.8.5 Ensure that adequate vertical dimensioning is provided for thefloorto-floor height, all openings, the depth of footZrtgs belmgrade, etc.8.6 Check the insulation of the foundation walls, the slabs at grade,the waf ls, the roof, etc. , for location, insulatiun values, materialand fastening.8.7 Indicate the damp-proofing of structures below grade.8.8 Check the indication of subgrade drains.8.9 Show the parts of the structure behind the cutting plane inelevation.