SenseAir S8 - Sensors Tecnics, Honeywell

More documents

Recommendations

Info

MaintenanceThe models based on SenseAir ® S8 platform are basically maintenance free in normal environmentsthanks to the built-in self-correcting ABC algorithm. Discuss your application with SenseAir in order to getadvice for a proper calibration strategy.When checking the sensor accuracy, PLEASE NOTE that the sensor accuracy is defined at continuousoperation (at least 3 weeks after installation for sensors with long period ABC)!ABC (Automatic Baseline Correction)The default sensor OEM unit is maintenance free in normal environments thanks to the built-in selfcorrectingABC algorithm (Automatic Baseline Correction). This algorithm constantly keeps track of thesensor’s lowest reading over preconfigured time interval and slowly corrects for any long-term driftdetected as compared to the expected fresh air value of 400ppm (or 0.04% vol ) CO 2 .ABCparameterABC periodSpecification15 daysMax correction150 ppm (0.015% volume CO 2 ) typicalTable 4. ABC default configurations for SenseAir ® S8 Article no. 004-0-0050 and Article no. 004-0-0051CalibrationRough handling and transportation might result in a reduction of sensor reading accuracy. With time, theABC function will tune the readings back to the correct numbers. The default “tuning speed” is howeverlimited to about 150 ppm/week. For post calibration convenience, in the event that one cannot wait for theABC algorithm to cure any calibration offset, switch input is defined for the operator or master system toselect one out of two prepared calibration codes. One of internal calibration codes is bCAL (backgroundcalibration), in which case it is assumed that the sensor is operating in a fresh air environment (400 ppmCO 2 ). Another operation code is CAL (zero calibration), in which case the sensor must be purged by somegas mixture free from CO 2 (i.e. Nitrogen or Soda Lime CO 2 scrubbed air). Make sure that the sensorenvironment is steady and calm!InputDefault functionbCAL_in(when closed for minimum 4, max 8 seconds)bCAL (background calibration) assuming 400 ppm CO 2 sensor exposureCAL_in(when closed for minimum 16 seconds)CAL (zero calibration) assuming 0 ppm CO 2 sensor exposureTable 5. Switch input default configurations for SenseAir ® S8
General mechanical overview6.1 ±0.15+0.732.2 -0.21.6 ±0.169.9 max2.97 ±0.1526.3 ±0.17.7 ±0.157.6 ±0.152.3 max13.2 ±0.22.549pins 110.7 ±0.219.6 ±0.13.18 ±0.1529.7 ±0.1Figure4a. Mechanical drawing SenseAir ® S8 Article No 004-0-0050
Page 1: Gas and Air SensorsProduct Specific
Page 4 and 5: Absolute maximum ratingsStress grea
Page 8: Figure 4b. Mechanical drawing Sense

SenseAir S8 - Sensors Tecnics, Honeywell

Create successful ePaper yourself

Delete template?

Save as template?