TimeLOG Version 9.3 - Synel

Getting Your System Up and Running TimeLOG Version 9.3Step 1.Click Find. .. at the bottom of the Terminal Setup screen to commuicate with the TimeLOG terminal.The following screen appears.Step 2.Click on the Search button. This will initiate communication with the terminal and cause ascreen similar to the one on the following page to appear. The settings will vary according to theactual communication parameters.If the search is unsuccessful, a message indicating that “No terminal was found!” will appear.In this case, check your cable connections and expand the search to the previous screen (above)by changing To COM2 to To COM4 and repeat step 2.If the search is still unsuccessful, click on the Max button and repeat step 2. This expandedsearch may take a full ten minutes since it searches for your terminal across all of the possiblecommunication parameters.Note:If a TimeLOG terminal still does not appear, refer to the Trouble Shooting section.Step 3.Click Update. This will update the TimeLOG software with current information regardingdefault TimeLOG definitions.34