TimeLOG Version 9.3 - Synel

Installation TimeLOG Version 9.3Note : Installation can be avoided if the HASP plug has already been installed.If it is a USB port installation you must first install the driver and only than insert the plug.Click either the Install HASP Net or the Install HASP button. Follow the wizard’s instructions. After theHASP has been successfully installed you can install TimeLOG software!Note : To share the HASP using the License Manager, TCP port 475 must be open on both the serverand its clients!2.2 SoftwareStep 1. Click the Install TimeLOG button. Navigate your way through the setup procedure.Step 2. The program automatically runs the setup. If during setup you are prompted to provide information,do so accordingly.A TimeLOG group, represented by the TimeLOG icon, is created, appearing under Programs.2.3 Connecting the TimeLOG clockRECOMMENDED INSTALLATION PROCEDURE:To understand how TimeLOG works, we suggest that you connect the terminal to your personal computerusing the direct (RS232) cable connection before mounting it in its final location. After installing thesoftware and performing a trial run, as described on chapter 4, you can mount the clock in its final location.Caution:The TimeLOG terminal should be opened by authorized and qualified service personnel only.TimeLOG software transfers the data collected from your TimeLOG clock to the computer where it is thenprocessed. Communication between the TimeLOG clock and your computer can take place in one of twoways: direct connection using a connection cable (standard model), or over a telephone line using amodem.2.3.1 Direct (RS232) cable connectionStep 1.Step 2.Remove the connector cover located on the bottom of the TimeLOG clock by pushing down withyour thumb nail, and pulling outward.Plug the end of the communication cable into the communication socket on the bottom left of theTimeLOG clock.Step 3.Replace the connector cover that was removed in step 1. All of the cables should come throughthe back of the TimeLOG clock.20