TimeLOG Version 9.3 - Synel

Setting Up Terminals TimeLOG Version 9.3Constant message - Displays a message to be displayed when a badge is accepted. You can entera message of up to 16 characters.Badge number - Displays the badge number.Employee name - Displays the employee nameName + Total - An informative option not for reporting. Displays the employee name and adaily or periodic, overtime and missing time totals.Balance - Displays the employees missing time (-) or overtime (+) update for the current day.Total - An informative option not for reporting. Displays a daily, periodic, overtime and missingtime totals and will not record a clocking.Absence balance - Display the balance according to the selected balance type. (The balance typeis defined under Reports | Balance Report | Daily balance Report | Customize).Display birthday message - Displays a message on the date of the employees birthday, that isdefined in the Personal data tab in Personnel.This message will only be displayed if the employee’s date of birth is defined in the Personnelfile.Display personal message - Displays a personal messages set for the employee.When more than one of the messages is selected, TimeLOG will display the message with thehighest priority as follows: Personal message, Birthday message, and lastly Display whenbadge accepted.Default project - This setting is shared by all of the clocks function keys.Verify project - Checks the project and it’s validity before accepting the transaction.Action - Specifies the actions to check. Marking this parameter activates the action options tocheck.Verify badge - Checks the badge number and its validity date with the employee list beforeunlocking a door. If you select this option, also set the Time open relay.Disable finger check - Disables the fingerprint option for Access control.Time open relay - Specify the number of seconds to open the door. Can be up to 50.Display last transaction - An informative option not for reporting. Displays the employee’s lasttransaction.Disable duplicate punches Blocks more than one swipe by the same badge during the definedtime frame. This option requires updating whenever you add new employees from either thePersonnel or Communication screens. If this option is selected, new employees will not be ableto clock-in until you have entered them into the database and updated.8.4 Terminal Setup for SY- 785 and SY- 795 TerminalsUp to 6 functions can be set for each SY- 785 and SY- 795 Terminal key. The functions are selected in theterminal by pressing the key a number of times through the available functions defined for the key.In addition to the settings defined here certain settings can be defined for the SY-785 and SY-795terminals in RDY format. To enable doing so, set the following in the general.ini file:[PROTOCOL]...SysParam_Polling_Interval=0163