GSM 11.11 version 6.2.0 - TTFN Smart card pages

(GSM 11.11 version 6.2.0 Release 1997)47TS 100 977 V6.2.0 (1999-05)9.4.5 Security managementSW1 SW2 Error description'98' '02' - no CHV initialized'98' '04' - access condition not fulfilled- unsuccessful CHV verification, at least one attempt left- unsuccessful UNBLOCK CHV verification, at least one attempt left- authentication failed (see note)'98' '08' - in contradiction with CHV status'98' '10' - in contradiction with invalidation status'98' '40' - unsuccessful CHV verification, no attempt left- unsuccessful UNBLOCK CHV verification, no attempt left- CHV blocked- UNBLOCK CHV blocked'98' '50' - increase cannot be performed, Max value reachedNOTE:A Phase 1 SIM may send this error code after the third consecutive unsuccessful CHV verification attemptor the tenth consecutive unsuccessful unblocking attempt.9.4.6 Application independent errorsSW1 SW2 Error description'67' 'XX' - incorrect parameter P3 (see note)'6B' 'XX' # - incorrect parameter P1 or P2 (see ## )'6D' 'XX' # - unknown instruction code given in the command'6E' 'XX' # - wrong instruction class given in the command'6F' 'XX' # - technical problem with no diagnostic given# These values of 'XX' are specified by ISO/IEC; at present the default value 'XX'='00' is the only one defined.## When the error in P1 or P2 is caused by the addressed record being out of range, then the return code '94 02' shall beused.NOTE:'XX' gives the correct length or states that no additional information is given ('XX' = '00').9.4.7 Commands versus possible status responsesThe following table shows for each command the possible status conditions returned (marked by an asterisk *).ETSI