GSM 11.11 version 6.2.0 - TTFN Smart card pages

(GSM 11.11 version 6.2.0 Release 1997)37TS 100 977 V6.2.0 (1999-05)9.2 Coding of the commandsTable 9 below gives the coding of the commands. The direction of the data is indicated by (S) and (R), where (S) standsfor data sent by the ME while (R) stands for data received by the ME. Offset is coded on 2 bytes where P1 gives thehigh order byte and P2 the low order byte. '00 00' means no offset and reading/updating starts with the first byte while anoffset of '00 01' means that reading/updating starts with the second byte.In addition to the instruction codes specified in table 9 the following codes are reserved:GSM operational phase:'1X' with X even, from X=6 to X=E.Administrative management phase:'2A', 'D0', 'D2', 'DE', 'C4', 'C6', 'C8', 'CA', 'CC', 'B4', 'B6', 'B8', 'BA' and 'BC'.Table 9: Coding of the commandsCOMMAND INS P1 P2 P3 S/RSELECT 'A4' '00' '00' '02' S/RSTATUS 'F2' '00' '00' lgth RREAD BINARY 'B0' offset high offset low lgth RUPDATE BINARY 'D6' offset high offset low lgth SREAD RECORD 'B2' rec No. mode lgth RUPDATE RECORD 'DC' rec No. mode lgth SSEEK 'A2' '00' type/mode lgth S/RINCREASE '32' '00' '00' '03' S/RVERIFY CHV '20' '00' CHV No. '08' SCHANGE CHV '24' '00' CHV No. '10' SDISABLE CHV '26' '00' '01' '08' SENABLE CHV '28' '00' '01' '08' SUNBLOCK CHV '2C' '00' see note '10' SINVALIDATE '04' '00' '00' '00' -REHABILITATE '44' '00' '00' '00' -RUN GSM ALGORITHM '88' '00' '00' '10' S/RSLEEP 'FA' '00' '00' '00' -GET RESPONSE 'C0' '00' '00' lgth RTERMINAL PROFILE '10' '00' '00' lgth SENVELOPE 'C2' '00' '00' lgth S/RFETCH '12' '00' '00' lgth RTERMINAL RESPONSE '14' '00' '00' lgth SNOTE:If the UNBLOCK CHV command applies to CHV1 then P2 is coded '00'; if it applies to CHV2 then P2 iscoded '02'.Definitions and codings used in the response parameters/data of the commands are given in subclause 9.3.9.2.1 SELECTCOMMAND CLASS INS P1 P2 P3SELECT 'A0' 'A4' '00' '00' '02'Command parameters/data:Byte(s) Description Length1 - 2 File ID 2ETSI