TURBOmax VUW 282 E - Heatingspares247.com

7.1.3 Removal of front casing7.1.3.1 Door (fig. 52)• Remove bottom hinge screw (1)and pull the bottom door panelforwards and down to release itfrom top hinge pin (2).7.1.3.2 Top panel (fig. 53)• Slide top panel upwards to releaseretaining clips (1).7.1.3.3 Bottom cover plate (fig. 51)• Remove two screws (1) and slackentwo screws (2).• Slide cover forwards and dropdown to remove7.1.3.4 Reassembly• Reassemble in reverse order.7.1.4 Removal of side casings• Remove front casing as in section7.1.3.• Remove screws (3, fig. 53)• Remove screws (4, fig. 53) andretaining brackets.• Slide side case panel upwards torelease retaining clips (2, fig. 53)and lift off.• Reassemble in reverse order7.1.5 Removal of combustion chambercover (fig. 54).• Remove front casing as in section7.1.3,• Remove four screws (2) securingcombustion chamber front cover• Lift combustion chamber cover clearof top retaining lugs and pullforward• Remove combustion chamber coverby first bringing the left sideforward to clear boiler casing.• Check condition of case seal and ifnecessary replace before refitting• Reassemble in reverse order,ensuring that the combustionchamber front cover is correctlyfitted and a good seal obtained.7.1.6 Lower front control panel(fig. 54)• Remove front casing as in section7.1.3,• Undo screw (1) and lower controlbox forward from top.7.1.7 Removal of heat exchangerfront panel.• Remove the five screws (1 and 3,fig. 47) securing the heat exchangerand remove the panel by gentlypulling down and forward.fig. 51fig. 52fig. 53GW 611/0GW 606/0GW 605/0fig. 54GW 613/033