Instruction manual Emotron VSA

• When the connection between the VSD and the motoris too long, consider the voltage drop of the circuit.Phase-to-phase voltage drop (V) = 3×resistance of wire (/km)×length of line (m)×current×10-3. And the carrierfrequency must be adjusted based on the length of theline.The length of the line between the VSD andthe motorBelow 25 m Below 50 m Below 100 m Over 100 mCarrier Frequency Below 16 kHz Below 12 kHz Below 8 kHz Below 5 kHzSettings in menu [226] 16 12 8 52.4 VSD Specification2.4.1 Basic specification230 V modelModelSingle phase VSAMax.Applicable Motor output.HP*1 (kW)0.25(0.2)23-01 23-03 23-04 23-07 23-100.5(0.4)1(0.75)Rated output current (A) 1.7 3.1 4.2 7.5 10.5Rated capacity (kVA) 0.53 0.88 1.60 2.90 4.002(1.5)3(2.2)Input voltage range (V)Output voltage range (V)1PH, 200 to 240V+10%,-15%(50/60Hz)3PH 0 to 240VInput current (A) 4.3 5.4 10.4 15.5 21VSD with filter weight kb (kg) 1.57 (0.71) 1.71 (0.73) 1.71 (0.73) 2.76 (1.25) 2.87 (1.3)Maximum momentary power loss time (S) 1.0 1.0 1.0 2.0 2.0EnclosureIP20460 V modelModelThree phase VSAVSA48-002 VSA48-004 VSA48-005Max.applicable Motor Output HP*1 (kW) 1.0 (0.75) 2.0 (1.50) 3.0 (2.2)Rated output current (A) 2.3 3.8 5.2Rated capacity (kVA) 1.7 2.9 4.0Input voltage range (V)Output voltage range (V)3PH 380 to 480V+10%,-15% (50/60Hz)3PH 0 to 480VInput current (A) 3 4.8 6.6VSD with filter Weight Lb. (kg) 3.70 (1.37) 3.75 (1.4) 3.82 (1.45)Maximum momentary power loss time (S) 1.0 2.0 2.0EnclosureIP20* Based on a 4-Pole Motor14 Mounting and installation of the VSA drive Emotron AB 01-3993-01r3