TP11KAC-D Instruction Manual - Auto Body Toolmart

165948 Two Post Lift Installation and Owners Manuala. Standard Height and High Rise Models – The tee should be attached to the mainsidecylinder and the elbow on the offside.b. For Extended Height Models – Cut a piece of return line tubing equal to the length ofthe upright. Attach this piece of tubing to the mainside return port fitting, attach the teeto the other end of the tubing. Push the tee up through the top of the mainside upright.Run one end of the remaining tubing down through the offside upright and attach it tothe offside return port fitting.D. Install the cylinders to the uprights or cylinder mounts with 1/2” x 4-1/2” Grade 8 bolts,cylinder bushings (spacers), washers, and nyloc nuts, figure 4. The portnear the rod end of the cylinders should be positioned pointing to the leg’s open side. HighRise cylinders must be attached to the alternate hole near the top of the upright.E. Connect the shortest hydraulic hose to one of the runs on the JIC tee fitting.F. Connect the longest hydraulic hose to the other run on the JIC tee fitting.12